A B S T R A C TEncapsulation-based materials are produced introducing some small healing fluid-filled capsules in a matrix. These materials can self-heal when internal cracks intercept and break the capsules. If the healing agent is released, the crack can be sealed. However, this is not always the case. These capsules need to be designed with the adequate shape and material to be properly broken. This paper presents two application models based on the combination of eXtended Finite Element Method (XFEM) elements and Cohesive Surfaces technique (CS) to predict crack propagation. Two types of encapsulated systems are considered: a concrete beam in a three-point bending test, and a micro-scale model of a representative volume element of a polymer subjected to a uniaxial tensile test. Despite both systems relying on different capsule shapes and different constituent materials, the models predict a similar non-linear response of the overall material strength governed by the coupled effect of the interface strength and the capsule radii-to-thickness ratio. Furthermore, even if an inadequate material and geometry combination is used, it is found that the mere presence of capsules might achieve, under certain conditions, an interesting overall reinforcement effect. This effect is discussed in terms of clustering and volume fraction of capsules.

No abstract

The behaviour of a tungsten first wall is studied under the irradiation conditions predicted for the different operational scenarios of the European laser fusion project HiPER, which is based on direct drive targets and an evacuated dry wall chamber. The scenarios correspond to different stages in the development of a nuclear fusion reactor, from proof of principle (bunch mode facility) to economic feasibility (pre-commercial power plant). This work constitutes a quantitative study to evaluate first wall performance under realistic irradiation conditions in the different scenarios. We calculated the radiation fluxes assuming the geometrical configurations reported so far for HiPER. Then, we calculated the irradiation-induced evolution of first wall temperature and the thermomechanical response of the material. The results indicate that the first wall will plastically deform up to a few microns underneath the surface. Continuous operation in a power plant leads to fatigue failure with crack generation and growth. Finally, crack propagation and the minimum tungsten thickness required to fulfil the first wall protection role is studied. The response of tungsten as a first wall material as well as its main limitations will be discussed for the HiPER scenarios.

No abstract