Charge carrier dynamics in perovskite CH3NH3PbI3 solar cells were studied by means of microscopic photoluminescence (PL) and photocurrent (PC) imaging spectroscopy. The PL intensity, PL lifetime, and PC intensity varied spatially on the order of several tens of micrometers. Simultaneous PL and PC image measurements revealed a positive correlation between the PL intensity and PL lifetime, and a negative correlation between PL and PC intensities. These correlations were due to the competition between photocarrier injection from the CH3NH3PbI3 layer into the charge transport layer and photocarrier recombination within the CH3NH3PbI3 layer. Furthermore, we found that the decrease in the carrier injection efficiency under prolonged light illumination leads to a reduction in PC, resulting in light-induced degradation of solar cell devices. Our findings provide important insights for understanding carrier injection at the interface and light-induced degradation in perovskite solar cells.

When continued device scaling reaches the ultimate limit imposed by atoms, technology based on atomically precise structures is expected to emerge. Device fabrication will then require building blocks with identified atomic arrangements and assembly of the components without contamination. Here we report on a versatile dry transfer technique for deterministic placement of optical-quality carbon nanotubes. Single-crystalline anthracene is used as a medium which readily sublimes by mild heating, leaving behind clean nanotubes and thus enabling bright photoluminescence. We are able to position nanotubes of a desired chirality with a sub-micron accuracy under in-situ optical monitoring, thereby demonstrating deterministic coupling of a nanotube to a photonic crystal nanobeam cavity. A cross junction structure is also designed and constructed by repeating the nanotube transfer, where intertube exciton transfer is observed. Our results represent an important step towards development of devices consisting of atomically precise components and interfaces.

We demonstrated 32-channel drop filters with 100 GHz spacing consisting of arrayed nanocavities and a waveguide in a photonic crystal silicon slab. Changing the lattice constant of the nanocavities on the subnanometer scale successfully controlled the drop wavelengths at 100 GHz spacing in the wavelength range between 1510 and 1550 nm. The device size was as small as 15 μm × 270 μm, and the variation in drop wavelengths was less than 0.3 nm in terms of standard deviation. We also present a movie showing the operation of the drop filter, demonstrating that the arrayed nanocavities have the potential for developing ultracompact 100 GHz spaced filters in a dense wavelength division multiplexing system.