No abstract

BackgroundThe objective of this study is to evaluate the skeletal and dentoalveolar effects of the crown Herbst appliance used alone for a single phase of therapy followed by a 1-year observation period.MethodsForty patients (mean age 13.6 ± 1.3 years) with a stable Class I occlusion 1 year following the treatment with the crown Herbst appliance were selected from a prospective sample of 180 consecutively treated Class II patients. No other appliances were used during treatment or during the follow-up period. The dentoskeletal changes were compared with a matched sample of untreated Class II subjects (mean age 13.9 ± 1.6 years). Lateral cephalograms were taken before treatment, after Herbst treatment (1 year), and after 1-year follow-up. Overcorrection was avoided intentionally.ResultsTreatment produced an increase in mandibular length, a decrease in ANB angle, and a restriction in the vertical growth of posterior maxilla. The maxillary molars moved backward and tipped distally. The lower incisors proclined markedly, and the upper incisors became retroclined. During the follow-up period, the changes primarily were dentoalveolar in nature, with marked rebound of the upper molars and lower incisors, resulting in some increases in overbite and overjet.ConclusionsThe occlusal correction of Class II malocclusion observed 1 year after the crown Herbst appliance as a single-phase therapy was achieved primary due to the dentoalveolar changes and only limited skeletal change occurred.

Dentofacial deformities usually are surgically treated, and 3D virtual planning has been used to favor accurate outcomes. Cases reported in the present article show that orthognathic surgery carried out to correct facial asymmetries does not comprise only one treatment protocol. 3D virtual planning might be used for surgical planning, but it should also be used to diagnose the deformity, thus allowing for an analysis of the best-recommended possibilities for the orthodontic preparation that suits each individual case.

ObjectiveTo measure aspartate aminotransferase (AST) activity in the pulp of teeth treated with fixed appliances for 6 months, and compare it with AST activity measured in untreated teeth.MethodsThe study sample consisted of 16 healthy subjects (mean age 25.7 ± 4.3 years) who required the extraction of maxillary premolars for orthodontic reasons. Of these, 6 individuals had a total of 11 sound teeth extracted without any orthodontic treatment (the control group), and 10 individuals had a total of 20 sound teeth extracted after 6 months of orthodontic alignment (the experimental group). Dental pulp samples were extracted from all control and experimental teeth, and the AST activity exhibited by these samples was determined spectrophotometrically at 20℃.ResultsMean AST values were 25.29 × 10-5 U/mg (standard deviation [SD] 9.95) in the control group and 27.54 × 10-5 U/mg (SD 31.81) in the experimental group. The difference between these means was not statistically significantly (p = 0.778), and the distribution of the AST values was also similar in both groups.ConclusionsNo statistically significant increase in AST activity in the pulp of mechanically loaded teeth was detected after 6 months of orthodontic alignment, as compared to that of teeth extracted from individuals who had not undergone orthodontic treatment. This suggests that time-related regenerative processes occur in the dental pulp.