No abstract

No abstract

Oxygen mass transfer represents the most important parameter involved in the design and operation of mixing-sparging equipment for bioreactors. It can be described and analyzed by means of the mass transfer coefficient, k(L) a. The k(L) a values are affected by many factors such as geometrical and operational characteristics of the vessels, media composition, type, concentration and microorganism morphology, and biocatalysts properties. The efficiency of oxygen transfer could be enhanced by adding oxygen-vectors in broths, such as hydrocarbons or fluorocarbons, without increasing the energy consumption for mixing or aeration. The experimental results obtained for simulated broths indicated a considerable increase of k(L) a in the presence of n-dodecane, and the existence of a certain value of n-dodecane concentration that corresponds to a maximum mass transfer rate of oxygen. The magnitude of the positive effect of n-dodecane depends both on the broths' characteristics and operational conditions of the bioreactor.

No abstract

The complexity of downstream processes for biosynthetic products constitutes a particularity of industrial biotechnologies, especially because of the biosynthetic product high dilution in fermentation broth, their chemical and thermal liability and the presence of secondary products. For these reasons, new separation techniques have been developed and applied to bioseparations. Among them, reactive extraction, pertraction (extraction and transport through liquid membranes) and direct extraction from broths have considerable potential and are required for the further development of many biotechnologies. This review is structured on two parts and presents our original results of the studies on the separation of some biosynthetic products (antibiotics, carboxylic acids, amino acids, alcohols) by reactive extraction in the first part, and by pertraction and direct extraction from broths without biomass filtration in the second. For all the analyzed cases, these extraction techniques simplify the technologies by reducing material and energy consumption, by avoiding product inhibition, by increasing the separation selectivity, therefore decreasing the overall cost of the product