Odontogenic cysts and tumors are mandibular and maxillary lesions that occur across all patient demographics across age, sex, race, and social economic status, as altered remnants of dental development. They may be incidental findings from routine imaging in any office or found through workup for craniofacial surgery or injury. Many of these patients present with asymptomatic lesions, whereas others may be symptomatic. In this article, we review the literature on the most common odontogenic tumors and cysts and discuss their presentation, their defining traits, and how to approach diagnosis and definitive management.

Kienböck disease, osteonecrosis of the lunate, is a well-known but poorly understood complication seen by hand surgeons. This review presents the background and important patient-specific parameters of the disease and reviews the numerous treatment options that exist for the disease.

No abstract

The purpose of this study was to compare the gap formation during cyclic loading, maximum repair strength, and failure mode of single-row full-thickness supraspinatus repairs performed using 2 knotless suture anchors with differing internal suture-retention mechanisms in a human cadaver model. Nine matched pairs of cadaver shoulders were used. Full-thickness tears were induced by detaching the supraspinatus tendon from the greater tuberosity. Single-row repairs were performed with either type I (Opus Magnum PI; ArthroCare, Austin, Texas) or type II (ReelX STT; Stryker, Mahwah, New Jersey) knotless suture anchors. The repaired tendon was cycled from 10 to 90 N for 500 cycles, followed by load to failure. Gap formation was measured at 5, 100, 200, 300, 400, and 500 cycles with a video digitizing system. Anchor type or location (anterior or posterior) had no effect on gap formation during cyclic loading regardless of position (anterior, P=.385; posterior, P=.389). Maximum load to failure was significantly greater (P=.018) for repairs performed with type II anchors (288±62 N) compared with type I anchors (179±39 N). Primary failure modes were anchor pullout and tendon tearing for type II anchors and suture slippage through the anchor for type I anchors. The internal ratcheting suture-retention mechanism of type II anchors may have helped this anchor outperform the suture-cinching mechanism of type I anchors by supporting significantly higher loads before failure and minimizing suture slippage, potentially leading to stronger repairs clinically.

Background We investigated the use of a conduit splinting technique to mitigate tension at the coaptation site of a rodent nerve defect model to determine the optimal reconstruction method for segmental nerve defects. Methods A rat sciatic nerve segmental defect model was created by excising 5mm of the sciatic nerve unilaterally. Four groups of 10 rats were each reconstructed using 1 of 4 techniques: primary repair, repair with conduit splinting, reverse isograft with conduit splinting, and reverse isograft without splinting. Functional outcomes were assessed at 6 weeks by measurement of Sciatic Functional Index (SFI), and sciatic nerves were harvested at the nonsurvival surgery. Histomorphologic measurements were reported as a value normalized to the average measurements of the control side. The primary outcomes were assessment of nerve continuity and the proportion of nerve fibers in the regenerating nerve compared with the uninjured side. Results The number of repair site rupture rates was lower when a conduit splint was used—less than half of the primary repairs under tension remained intact at 6 weeks. No difference was seen in axon number, size, and density between primary repairs and those augmented by conduit splints, but worse functional outcomes and more debris were present compared with the intact primary repairs. Conclusions Nerve conduit splinting reduced rupture rates, particularly for nerve repairs associated with a segmental defect. No significant difference was seen in the number of axons among techniques. Primary nerve repair under tension that did not rupture demonstrated superior SFI.