Currently, there is a lack of nonvolatile memory (NVM) technology that can operate continuously at temperatures >200 °C. While ferroelectric NVM has previously demonstrated long polarization retention and >1013 read/write cycles at room temperature, the largest hurdle comes at higher temperatures for conventional perovskite ferroelectrics. Here, we demonstrate how AlScN can enable high-temperature (>200 °C) nonvolatile memory. The c-axis textured thin films were prepared via reactive radiofrequency magnetron sputtering onto a highly textured Pt (111) surface. Photolithographically defined Pt top electrodes completed the capacitor stack, which was tested in a high temperature vacuum probe station up to 400 °C. Polarization–electric field hysteresis loops between 23 and 400 °C reveal minimal changes in the remanent polarization values, while the coercive field decreased from 4.3 MV/cm to 2.6 MV/cm. Even at 400 °C, the polarization retention exhibited negligible loss for up to 1000 s, demonstrating promise for potential nonvolatile memory capable of high−temperature operation. Fatigue behavior also showed a moderate dependence on operating temperature, but the mechanisms of degradation require additional study.

Epitaxial ferroelectric wurtzite films exhibiting clear polarization-electric field hysteresis behavior are presented. The coercive field of this epitaxial Al0.7Sc0.3N film on the W/c-sapphire substrate is 0.4 ± 0.3 MV cm−1 (8%) smaller than that of a conventional fiber textured film on a Pt/TiOx/SiO2/Si substrate, attributed to the 0.01 ± 0.007 Å smaller c-axis lattice parameter in the epitaxial film. The strain and decrease in the coercive field most likely originate from epitaxial strain rather than the mismatch in the thermal coefficient of expansion. These results provide insight for further coercive field reduction of wurtzite ferroelectrics using epitaxial mismatch strain.