AimsIn 2013, we introduced a specialized, centralized, and interdisciplinary team in our institution that applied a standardized diagnostic and treatment algorithm for the management of prosthetic joint infections (PJIs). The hypothesis for this study was that the outcome of treatment would be improved using this approach.Patients and MethodsIn a retrospective analysis with a standard postoperative follow-up, 95 patients with a PJI of the hip and knee who were treated with a two-stage exchange between 2013 and 2017 formed the study group. A historical cohort of 86 patients treated between 2009 and 2011 not according to the standardized protocol served as a control group. The success of treatment was defined according to the Delphi criteria in a two-year follow-up.ResultsPatients in the study group had a significantly higher Charlson Comorbidity Index (3.9 vs 3.1; p = 0.009) and rate of previous revisions for infection (52.6% vs 36%; p = 0.025), and tended to be older (69.0 vs 66.2 years; p = 0.075) with a broader polymicrobial spectrum (47.3% vs 33.7%; p = 0.062). The rate of recurrent infection (3.1% vs 10.4%; p = 0.048) and the mean time interval between the two stages of the procedure (66.6 vs 80.7 days; p < 0.001) were reduced significantly in the study group compared with the control group.ConclusionWe were able to show that the outcome following the treatment of PJIs of the hip and knee is better when managed in a separate department with an interdisciplinary team using a standard algorithm.

Aims The worldwide COVID-19 pandemic is directly impacting the field of orthopaedic surgery and traumatology with postponed operations, changed status of planned elective surgeries and acute emergencies in patients with unknown infection status. To this point, Germany's COVID-19 infection numbers and death rate have been lower than those of many other nations. Methods This article summarizes the current regimen used in the field of orthopaedics in Germany during the COVID-19 pandemic. Internal university clinic guidelines, latest research results, expert consensus, and clinical experiences were combined in this article guideline. Results Every patient, with and without symptoms, should be screened for COVID-19 before hospital admission. Patients should be assigned to three groups (infection status unknown, confirmed, or negative). Patients with unknown infection status should be considered as infectious. Dependent of the infection status and acuity of the symptoms, patients are assigned to a COVID-19-free or affected zone of the hospital. Isolation, hand hygiene, and personal protective equipment is essential. Hospital personnel directly involved in the care of COVID-19 patients should be tested on a weekly basis independently of the presence of clinical symptoms, staff in the COVID-19-free zone on a biweekly basis. Class 1a operation rooms with laminar air flow and negative pressure are preferred for surgery in COVID-19 patients. Electrocautery should only be utilized with a smoke suction system. In cases of unavoidable elective surgery, a self-imposed quarantine of 14 days is recommended prior to hospital admission. Conclusion During the current COVID-19 pandemic, orthopaedic patients admitted to the hospital should be treated based on an interdisciplinary algorithm, strictly separating infectious and non-infectious cases. Cite this article: Bone Joint Open 2020;1-6:309–315.

Introduction: The risk of prosthetic joint infection (PJI) in mega-prosthesis for malignancy is increased compared with non-tumor cases. While several studies describe PJI in tumor-related arthroplasty, prospective studies comparing infection characteristics among different joints are limited. The present study analyzes mega-arthroplasty for hip, knee, and shoulder malignancy and compares the epidemiology, diagnosis, microbe spectrum, treatments, and outcomes between the different entities. Methods: The retrospective inclusion criteria were as follows: (1) mega-arthroplasty (2) in the hip, knee, or shoulder joint and a total femur arthroplasty (3) following a malignant bone tumor or metastasis (4) between 1996 and 2019. All included patients were prospectively followed and invited for a renewed hospital examination, and their PJI characteristics (if identified) were analyzed using both retrospective as well as newly gained prospective data. A PJI was defined according to the Infectious Disease Society of America (IDSA) and re-infection was defined according to the modified Delphi Consensus criteria. Results: In total, 83 cases of tumor mega-arthroplasty at a mean follow-up of 3.9 years could be included (32 knee, 30 hip, and 19 shoulder cases and 2 cases of total femur arthroplasty). In total, 14 PJIs were identified, with chondrosarcoma in 6 and osteosarcoma in 3 being the leading tumor entities. Knee arthroplasty demonstrated a significantly higher rate of PJI (p = 0.027) compared with hips (28.1% vs. 6.7%), while no significant difference could be found between the knee and shoulder (10.5%) (p = 0.134) or among shoulder and hip cases (p = 0.631). The average time of PJI following primary implantation was 141.4 months in knee patients, 64.6 in hip patients, and 8.2 months in shoulder patients. Age at the time of the primary PJI, as well as the time of the first PJI, did not show significant differences among the groups. Thirteen of the fourteen patients with PJI had a primary bone tumor. Statistical analysis showed a significant difference in the disadvantage of primary bone tumors (p = 0.11). While the overall cancer-related mortality in the knee PJI group (10%) was low, it was 50% in the hip and 100% in the shoulder group. Conclusion: The risk of PJI in knee tumor arthroplasty is significantly increased compared with hips, while cancer-related mortality is significantly higher in hip PJI cases. At the same time, mega-prostheses appear to be associated with a higher risk of infection due to a primary bone tumor compared with metastases. The study confirms existing knowledge concerning PJI in tumor arthroplasty, while, being one of the few studies to compare three different joints concerning PJI characteristics.