The function of a frequency multiplier is verbatima frequency multiplier is a circuit that takes a signal of particular frequency at the input and produces harmonic multiples of the input signal's frequency at the output. Their use is widespread throughout history, primarily in the application of frequency synthesis. When implemented as a part of a large system, a chain of multipliers can be used to synthesize multiple reference signals from a single high-performance reference oscillator. Frequency multiplier designs use a variety of nonlinear devices and topologies to achieve excitation of harmonics. This thesis will focus on the design and analysis of single ended bipolar junction transistor frequency multipliers. This topology serves as a relatively simple design that lends itself to analysis of device parasitics and nonlinearities. In addition, design is done in the Very High Frequency (VHF) band of 30-300 MHz to allow for design and measurement freedoms. However, the design methodologies and theory can be frequency scaled as needed. The parasitics and nonlinearities of frequency multipliers are well explored on the output side of circuit design, but literature is lacking in analysis of the drive network. In order to explore device nonlinearities on the drive side of the circuit, this thesis implements novel nonlinear reflectometry systems in both simulations and real-world testing. The simulation nonlinear reflectometry consists of intelligently configured voltage sources, whereas directional couplers allow for real world nonlinear reflectometry measurements. These measurements allow for harmonically rich reflected waveforms to be accurately measured, allowing for waveform engineering to be performed at the drive network. Further, nonlinear reflectometry measurements can be

A model is proposed to describe the field-assisted molten salt ion exchange of N a + with A g + in glass. It accounts for the buildup of space-charge zones and for the pseudo-mixed-alkali effect. Simulations in 1D proved to be consistent with experimental results. The 1D model has been expanded to 2D, making it suitable for simulating the fabrication of channel waveguides. Using a first-order approximation, a good agreement between the simulations and the experimental data can be achieved.

Abstract-This project aims to provide students and researchers with low cost, low power, lightweight probes for characterizing natural phenomena. To achieve this, the probes are designed using the modulated scattering technique, which in this application provides a system somewhat analogous to a hybrid radar and RFID system. The achieved design is one square inch in area, less than 10 grams, and easily has a battery life of over 20 days using two CR2032 batteries in series.

Asymmetric optical multimode splitters based on optical waveguides were fabricated in glass substrates using a field-assisted ion exchange process. Accompanying simulations, conducted to study the light propagation, revealed the possibility to realize asymmetric splitters based on waveguides with different width. In the exchange process, broad mask openings in the blocking layer are compared to those consisting of closely spaced parallel lines with various widths. The waveguide profiles of the resulting splitters were recorded and the optical losses and splitting ratios were determined for a wavelength of 850 nm. Additionally data transmission tests were conducted and showed the suitability of the splitters for a bandwidth of 28 GBit/s.

This erratum reports corrections for the original publication, Appl. Opt. 60, 6632 (2021)APOPAI0003-693510.1364/AO.427171.