We studied meibum architecture and its relation to bulk and interfacial rheology. Bovine and human meibomian lipids exhibit similar physical properties. From all structural probes utilized, we find a melt transition near eye temperature at which lamellar crystals liquefy. Our proposed structure for the tear-film lipid layer at physiologic temperature is a highly viscoelastic, shear-thinning liquid suspension consisting of lipid lamellar-crystallite particulates immersed in a continuous liquid phase with no long-range order. When spread over on-eye tear, the TFLL is a duplex film that exhibits bulk liquid properties and two separate interfaces, air/lipid and water/lipid, with aqueous protein and surfactantlike lipids adsorbed at the water/lipid surface.

Proteins are surface-active molecules that have a propensity to adsorb to hydrophobic interfaces, such as the air-liquid interface. Surface flow can increase aggregation of adsorbed proteins, which may be an undesirable consequence depending on the application. As changes in protein conformation upon adsorption are thought to induce aggregation, the ability to measure the folded state of proteins at interfaces is of particular interest. However, few techniques currently exist to measure protein conformation at interfaces. Here we describe a technique capable of measuring the hydrophobicity, and therefore the conformation and folded state, of proteins at air-liquid interfaces by exploiting the environmentally sensitive fluorophore Nile red. Two monoclonal antibodies (mAbs) with high (mAb1) and low (mAb2) surface activity were used to highlight the technique. Both mAbs showed low background fluorescence of Nile red in the liquid subphase and at a glass-liquid interface. In contrast, at the air-liquid interface Nile red fluorescence for mAb1 increased immediately after protein adsorption, whereas the Nile red fluorescence of the mAb2 film evolved more slowly in time even though the adsorbed quantity of protein remained constant. The results demonstrate that hydrophobicity upon mAb adsorption to the air-liquid interface evolves in a time-dependent manner. Interfacial hydrophobicity may be indicative of protein conformation or folded state, where rapid unfolding of mAb1 upon adsorption would be consistent with increased protein aggregation compared to mAb2. The ability to measure protein hydrophobicity at interfaces using Nile red, combined with small sample requirements and minimal sample preparation, fills a gap in existing interfacial techniques.

Meibum is the primary component of the tear film lipid layer. Thought to play a role in tear film stabilization, understanding the physical properties of meibum and how they change with disease will be valuable in identifying dry eye treatment targets. Grazing incidence X-ray diffraction and X-ray reflectivity were applied to meibum films at an air-water interface to identify molecular organization. At room temperature, interfacial meibum films formed two coexisting scattering phases with rectangular lattices and next-nearest neighbor tilts, similar to the Ov phase previously identified in fatty acids. The intensity of the diffraction peaks increased with compression, although the lattice spacing and molecular tilt angle remained constant. Reflectivity measurements at surface pressures of 18 mN/m and above revealed multilayers with d-spacings of 50 Å, suggesting that vertical organization rather than lateral was predominantly affected by meibum-film compression.

Monoclonal antibodies (mAbs) are proteins that uniquely identify targets within the body, making them well-suited for therapeutic applications. However, these amphiphilic molecules readily adsorb onto air-solution interfaces where they tend to aggregate. We investigated two mAbs with different propensities to aggregate at air-solution interfaces. The understanding of the interfacial rheological behavior of the two mAbs is crucial in determining their aggregation tendency. In this work, we performed interfacial stress relaxation studies under compressive step strain using a custom-built dilatational rheometer. The dilatational relaxation modulus was determined for these viscoelastic interfaces. The initial value and the equilibrated value of relaxation modulus were larger in magnitude for the mAb with a higher tendency to aggregate in response to interfacial stress. We also performed single-bubble coalescence experiments using a custom-built dynamic fluid-film interferometer (DFI). The bubble coalescence times also correlated to the mAbs aggregation propensity and interfacial viscoelasticity. To study the influence of surfactants in mAb formulations, polyethylene glycol (PEG) was chosen as a model surfactant. In the mixed mAb/PEG system, we observed that the higher aggregating mAb coadsorbed with PEG and formed domains at the interface. In contrast, for the other mAb, PEG entirely covered the interface at the concentrations studied. We studied the mobility of the interfaces, which was manifested by the presence or the lack of Marangoni stresses. These dynamics were strongly correlated with the interfacial viscoelasticity of the mAbs. The influence of competitive destabilization in affecting the bubble coalescence times for the mixed mAb/PEG systems was also studied.