No abstract

Cost management and scalable fabrication without sacrificing the purification performance are two critical issues that should be addressed before the practical commercial application of solar-driven evaporators. To address this challenge, we report a porous photothermal hydrogel coating prepared by mixing the raw materials of sawdust (SD), carbon nanotubes (CNTs), and poly­(vinyl alcohol) (PVA), which was applied to undergo a blading–drying–rehydration process to prepare the evaporator. In the coating, the crystallized PVA gives the coating a solid skeleton and the sawdust endows the coating with a loose structure to sufficiently enhance the water transportation capacity. As a result, the evaporator coated with the hydrogel coating displays a high water transport rate and efficient evaporation performance along with excellent mechanical properties and stability. Water migrates vertically upward 5 cm within 4 minutes. The compressive stress of the rehydrated hydrogel coating reaches as high as 14.28 MPa under 80% strain. The water evaporation rate of the hydrogel coating-based evaporator reaches 1.833 kg m–2 h–1 corresponding to an energy efficiency of 83.29% under 1 sun irradiation. What is more, the hydrogel coating retains its excellent evaporation performance and stability after immersion in acid or alkali solution, ultrasound treatment, and long-time immersion in water. Under outdoor conditions, the water evaporation rate of the hydrogel coating-based evaporator is about 5.69 times higher than that of pure water. This study proposes a rapid, cost-effective, and scalable strategy for preparing a high-performance photothermal hydrogel coating that will find sustainable and practical application in solar-driven water purification.

No abstract