Twenty-five different temperature-sensitive point mutations at 20 sites in the lysozyme gene of bacteriophage T4 have been identified. All of the mutations alter amino acid side chains that have lower than average crystallographic thermal factors and reduced solvent accessibility in the folded protein. This suggests that the amino acids with well-defined conformations can form specific intramolecular interactions that make relatively large contributions to the thermal stability of the protein. Residues with high mobility or high solvent accessibility are much less susceptible to destabilizing substitutions, suggesting that, in general, such amino acids contribute less to protein stability. The pattern of the sites of ts substitutions observed in the folded conformation of T4 lysozyme suggests that severe destabilizing mutations that primarily affect the free energy of the unfolded state are rare. These results indicate that proteins can be stabilized by adding new interactions to regions that are rigid or buried in the folded conformation.

Measurements of changes in structure and stability caused by 13 different substitutions for threonine 157 in phage T4 lysozyme show that the most stable lysozyme variants contain hydrogen bonds analogous to those in the wild-type enzyme and that structural adjustments allow the protein to be surprisingly tolerant of amino-acid substitutions.

Substitution of Thr26 by Gln in the lysozyme of bacteriophage T4 produces an enzyme with greatly reduced activity but essentially unaltered stability relative to wild type. Spontaneous second-site revertants of the mutant were selected genetically; two of them were chosen for structural and biochemical characterization. One revertant bears (in addition to the primary mutation) the substitution Tyr18----His, the other, Tyr18----Asp. The primary mutant and both revertant lysozyme genes were reconstructed in a plasmid-based expression system, and the proteins were produced and purified. The two revertant lysozymes exhibit enzymatic activities intermediate between wild type and the primary mutant; both also exhibit melting temperatures approximately 3 degrees C lower than either the wild type or the primary mutant. Crystals suitable for X-ray diffraction analysis were obtained from both revertant lysozymes, but not the primary mutant. Structures of the double mutant lysozymes were refined at 1.8-A resolution to crystallographic residuals of 15.1% (Tyr18----His) and 15.2% (Tyr18----Asp). Model building suggests that the side chain of Gln26 in the primary mutant is forced to protrude into the active site cleft, resulting in low catalytic activity. In contrast, the crystal structures of the revertants reveal that the double substitutions (Gln26 and His18, or Gln26 and Asp18) fit into the same space that is occupied by Thr26 and Tyr18 in the wild-type enzyme; the effect is a restructuring of the surface of the active site cleft, with essentially no perturbation of the polypeptide backbone. This restructuring is effected by a novel series of hydrogen bonds and electrostatic interactions that apparently stabilize the revertant structures.

Six designed mutants of T4 lysozyme were created in an attempt to create putative salt bridges on the surface of the protein. The first three of the mutants, T115E (Thr 115 to Glu), Q123E, and N144E, were designed to introduce a new charged side chain close to one or more existing charged groups of the opposite sign on the surface of the protein. In each of these cases the putative electrostatic interactions introduced by the mutation include possible salt bridges between residues within consecutive turns of an alpha-helix. Effects of the mutations ranged from no change in stability to a 1.5 degrees C (0.5 kcal/mol) increase in melting temperature. In two cases, secondary (double) mutants were constructed as controls in which the charge partner was removed from the primary mutant structure. These controls proteins indicate that the contributions to stability from each of the engineered salt bridges is very small (about 0.1-0.25 kcal/mol in 0.15 M KCl). The structures of the three primary mutants were determined by X-ray crystallography and shown to be essentially the same as the wild-type structure except at the site of the mutation. Although the introduced charges in the T115E and Q123E structures are within 3-5 A of their intended partner, the introduced side chains and their intended partners were observed to be quite mobile. It has been shown that the salt bridge between His 31 and Asp 70 in T4 lysozyme stabilizes the protein by 3-5 kcal/mol [Anderson, D. E., Becktel, W. J., & Dahlquist, F. W. (1990) Biochemistry 29, 2403-2408]. To test the effectiveness of His...Asp interactions in general, three additional double mutants, K60H/L13D, K83H/A112D, and S90H/Q122D, were created in order to introduce histidine-aspartate charge pairs on the surface of the protein. Each of these mutants destabilizes the protein by 1-3 kcal/mol in 0.15 M KCl at pH values from 2 to 6.5. The X-ray crystallographic structure of the mutant K83H/A112D has been determined and shows that there are backbone conformational changes of 0.3-0.6 A extending over several residues. The introduction of the histidine and aspartate presumably introduces strain into the folded protein that destabilizes this variant. It is concluded that pairs of oppositely charged residues that are on the surface of a protein and have freedom to adopt different conformations do not tend to come together to form structurally localized salt bridges. Rather, such residues tend to remain mobile, interact weakly if at all, and do not contribute significantly to protein stability. It is argued that the entropic cost of localizing a pair of solvent-exposed charged groups on the surface of a protein largely offsets the interaction energy expected from the formation of a defined salt bridge. There are examples of strong salt bridges in proteins, but such interactions require that the folding of the protein provides the requisite driving energy to hold the interacting partners in the correct rigid alignment.

To investigate the relation between protein stability and the predicted stabilities of individual secondary structural elements, residue Pro86 in an alpha-helix in phage T4 lysozyme was replaced by ten different amino acids. The x-ray crystal structures of seven of the mutant lysozymes were determined at high resolution. In each case, replacement of the proline resulted in the formation of an extended alpha-helix. This involves a large conformational change in residues 81 to 83 and smaller shifts that extend 20 angstroms across the protein surface. Unexpectedly, all ten amino acid substitutions marginally reduce protein thermostability. This insensitivity of stability to the amino acid at position 86 is not simply explained by statistical and thermodynamic criteria for helical propensity. The observed conformational changes illustrate a general mechanism by which proteins can tolerate mutations.