A microfabricated ultrafast GC×GC system, coupled with highly sensitive, low-power NEMS resonators, with handheld form factor for civilian, military, and space applications.

Gas conductivities of narrow natural fractures in sandstone and chalk were measured under varying stress and pore pressure conditions and showed a decrease in conductivity with increasing net stress. Natural fractures in mudstones exhibited continuously decreasing conductivity upon application of stress, so that correlatable conductivity data could not be obtained. Effectivestress-law behavior for the sandstone and chalk fractures were examined, giving a values in the range of 0.8-1.06, where a is the parameter in the effective-stress law, u -aP. The value of a for the fracture in chalk was nearly constant, but the values for the fracture in sandstone tended to decrease with increasing stress. Transition Reynold's numbers and turbulence factors for flow through the chalk and sandstone fractures were determined, yielding turbulence factors ranging from 6.0-20xl0 6 ft-l (2.0-6.6xlO-5 cm-l ) for differently stressed fractures. The entire flow behavior of these natural fractures, including conductivity, effective-stress law, and turbulence, is controlled by stress and pore pressure. As a result, pressure depletion during production will significantly change the productivity of a reservoir with similar natural fractures.

The magnetically excited flexural plate wave (mag-FPW) device has great promise as a versatile sensor platform. FPW's can have better sensitivity at lower operating frequencies than surface acoustic wave (SAW) devices. Lower operating frequency (< 1 MHz for the FPW versus several hundred MHz to a few GHz for the SAW device) simplifies the control electronics and makes integration of sensor with electronics easier. Magnetic rather than piezoelectric excitation of the FPW greatly simplifies the device structure and processing by eliminating the need for piezoelectric thin films, also simplifying integration issues. The versatile mag-FPW resonator structure can potentially be configured to fulfill a number of critical functions in an autonomous sensored system. As a physical sensor, the device can be extremely sensitive to temperature, fluid flow, strain, acceleration and vibration. By coating the membrane with self-assembled monolayers (SAMs), or polymer films with selective absorption properties (originally developed for SAW sensors), the mass sensitivity of the FPW allows it to be used as biological or chemical sensors. Yet another critical need in autonomous sensor systems is the ability to pump fluid. FPW structures can be configured as micro-pumps. This report describes work done to develop mag-FPW devices as physical, chemical, and acoustic sensors, and as micro-pumps for both liquid and gas-phase analytes to enable new integrated sensing platform.4