No abstract

In recent years, multiple technologies have been proposed with the aim of combining the characteristics of traditional planar and non-planar transmission lines. The first and most popular of these technologies is the Substrate Integrated Waveguide (SIW), where rows of metallic vias are mechanized in a printed circuit board (PCB). These vias, together with the top and bottom metal layers of the PCB, form a channel for the propagation of the electromagnetic fields, similar to that of a rectangular waveguide, but through a dielectric body, which increases the losses. To reduce these losses, the empty substrate integrated waveguide (ESIW) was recently proposed. In the ESIW, the dielectric is removed from the substrate, and this results in better performance (low profile and easy manufacturing as in SIW, but lower losses and better quality factor for resonators). Recently, to increase the operational bandwidth (monomode propagation) of the ESIW, the ridge ESIW (RESIW) and a transition from RESIW to microstrip line was proposed. In this work, a new and improved wideband transition from microstrip line (MS) to RESIW, with a dielectric taper based on the equations of the superellipse, is proposed. The new wideband transition presents simulated return losses in a back-to-back transition greater than 20 dB in an 87% fractional bandwidth, while in the previous transition the fractional bandwidth was 82%. This is an increment of 5%. In addition, the transition presents simulated return losses greater than 26 dB in an 84% fractional bandwidth. For validation purposes, a back-to-back configuration of the new transition was successfully manufactured and measured. The measured return loss is better than 14 dB with an insertion loss lower than 1 dB over the whole band.

No abstract

The Empty Substrate Integrated Waveguides (ESIW) maintain the advantages of the Substrate Integrated waveguide (SIW) (i.e. low-volume, low profile, lightweight, easy manufacturing, and integration in a planar circuit board), and present lower losses and higher quality factors in resonators due to the propagation of the fields through air, instead of through lossy dielectric as in SIW. The operational (monomode) bandwidth of the ESIW can be increased with the Single Ridge ESIW (SRESIW). However, the bandwidth can be further increased with the Double Ridge ESIW (DRESIW). In this paper, a brief study of possible DRESIW geometries has been performed, and two transitions from microstrip line (MS) to DRESIW with a dielectric taper geometry based on different equations are proposed. The new wideband transitions present simulated return losses in back-to-back configurations greater than 20 dB in more than a 95% fractional bandwidth. The transition that presents a better compromise between return losses, bandwidth and ease of fabrication is manufactured. The measured return and insertion losses are better than 19.7 dB and 1.5 dB, respectively, in a 96.4% fractional bandwidth.

This paper presents a feasibility study for designing a floating patch antenna structure fed with a probe from a microstrip. The main premise is to eliminate the dielectric in the patch design, which is equivalent to having an air dielectric and leads to the necessity of proper support to fasten the patch in the air. The novelty of this paper is that this new device, apart from being fed with the though-wire technique directly from the microstrip line, has to be, by design, robust and easy to manufacture, and, at the same time, it has to present, simultaneously, good values in all of the performance indexes. A prototype has been designed, manufactured, and measured with good performance results: a bandwidth higher than 10% around 2.4 GHz, a radiation efficiency higher than 96%, a 9.63 dBi gain, and a wide beamwidth. The main advantages of this prototype, together with its good performance indexes, include its low fabrication cost, low losses, light weight, robustness, high integration capability, the complete removal of the dielectric material, and the use of a single post for feeding the patch while simultaneously fixing its floating position.