No abstract

The objective of this paper is to develop further a framework for computationally modeling microstructurally small fatigue crack growth in AA 7075-T651 (Bozek et al 2008 Modelling Simul. Mater. Sci. 16 065007). The focus is on the nucleation event, when a crack extends from within a secondphase particle into a surrounding grain, since this has been observed to be an initiating mechanism for fatigue crack growth in this alloy. It is hypothesized that nucleation can be predicted by computing a non-local nucleation metric near the crack front. The hypothesis is tested by employing a combination of experimentation and finite element modeling in which various slip-based and energy-based nucleation metrics are tested for validity, where each metric is derived from a continuum crystal plasticity formulation. To investigate each metric, a non-local procedure is developed for the calculation of nucleation metrics in the neighborhood of a crack front. Initially, an idealized baseline model consisting of a single grain containing a semi-ellipsoidal surface particle is studied to investigate the dependence of each nucleation metric on lattice orientation, number of load cycles and non-local regularization method. This is followed by a comparison of experimental observations and computational results for microstructural models constructed by replicating the observed microstructural geometry near second-phase particles in fatigue specimens. It

Microstructurally small fatigue crack (MSFC) formation includes stages of incubation, nucleation and microstructurally small propagation. In AA 7075-T651, the fracture of Al 7 Cu 2 Fe constituent particles is the major incubation source. In experiments, it has been observed that only a small percentage of these Fe-bearing particles crack in a highly stressed volume. The work presented here addresses the identification of the particles prone to cracking and the prediction of particle cracking frequency, given a distribution of particles and crystallographic texture in such a volume. Three-dimensional elasto-viscoplastic finite element analyses are performed to develop a response surface for the tensile stress in the particle as a function of the strain level surrounding the particle, parent grain orientation and particle aspect ratio. A technique for estimating particle strength from fracture toughness, particle size and intrinsic flaw size is developed. Particle cracking is then determined by comparing particle stress and strength. The frequency of particle cracking is then predicted from sampling measured distributions of grain orientation, particle aspect ratio and size. Good agreement is found between the predicted frequency of particle cracking and two preliminary validation experiments. An estimate of particle cracking frequency is important for simulating the next

A notion of material homogeneity is proposed for peridynamic bodies with variable horizon but constant bulk properties. A relation is derived that scales the force state according to the position-dependent horizon while keeping the bulk properties unchanged. Using this scaling relation, if the horizon depends on position, artifacts called ghost forces may arise in a body under a homogeneous deformation. These artifacts depend on the second derivative of the horizon and can be reduced by employing a modified equilibrium equation using a new quantity called the partial stress. Bodies with piecewise constant horizon can be modeled without ghost forces by using a simpler technique called a splice. As a limiting case of zero horizon, both the partial stress and splice techniques can be used to achieve local-nonlocal coupling. Computational examples, including dynamic fracture in a one-dimensional model with localnonlocal coupling, illustrate the methods.

Peridigm is Sandia's primary open-source computational peridynamics code. It is a component software project, built largely upon Sandia's Trilinos project and Sandia's agile software components efforts. It is massively parallel, utilizes peridynamic state-based material models, Exodus/Genesis-format mesh input, Exodus-format output, and multiple material blocks. It performs explicit dynamic, implicit dynamic, and quasistatic analyses utilizing powerful nonlinear and linear solvers.3