The synthesis of novel well-defined alkyne side chain functional polymers featuring narrow molecular weight distributions (PDI = 1.09−1.17) by living radical polymerization is described. Grafting of protected and unprotected carbohydrates is achieved via either a C-6 or an anomeric azide (α or β) onto these polymers by Cu(I)-catalyzed “click chemistry”, providing a simple and efficient route to synthetic glycopolymers. The strategy provides an extremely powerful tool for the synthesis of libraries of materials that differ only in the nature of the sugar moiety presented on a well-defined polymer scaffold. A library of multivalent ligands were then prepared following a “coclicking” synthetic protocol, and the reactivity of these glycopolymers in the presence of concanavalin A and Ricinus communis agglutinin, model lectins able to selectively bind appropriate mannose and galactose derivatives, respectively, was assessed.

A new approach to perform single-electron transfer living radical polymerization (SET-LRP) in water is described. The key step in this process is to allow full disproportionation of CuBr/Me6TREN (TREN = tris(dimethylamino)ethyl amine to Cu(0) powder and CuBr2 in water prior to addition of both monomer and initiator. This provides an extremely powerful tool for the synthesis of functional water-soluble polymers with controlled chain length and narrow molecular weight distributions (polydispersity index approximately 1.10), including poly(N-isopropylacrylamide), N,N-dimethylacrylamide, poly(ethylene glycol) acrylate, 2-hydroxyethyl acrylate (HEA), and an acrylamido glyco monomer. The polymerizations are performed at or below ambient temperature with quantitative conversions attained in minutes. Polymers have high chain end fidelity capable of undergoing chain extensions to full conversion or multiblock copolymerization via iterative monomer addition after full conversion. Activator generated by electron transfer atom transfer radical polymerization of N-isopropylacrylamide in water was also conducted as a comparison with the SET-LRP system. This shows that the addition sequence of l-ascorbic acid is crucial in determining the onset of disproportionation, or otherwise. Finally, this robust technique was applied to polymerizations under biologically relevant conditions (PBS buffer) and a complex ethanol/water mixture (tequila).

Photoinduced living radical polymerization of acrylates, in the absence of conventional photoinitiators or dye sensitizers, has been realized in "daylight'"and is enhanced upon irradiation with UV radiation (λ(max) ≈ 360 nm). In the presence of low concentrations of copper(II) bromide and an aliphatic tertiary amine ligand (Me6-Tren; Tren = tris(2-aminoethyl)amine), near-quantitative monomer conversion (>95%) is obtained within 80 min, yielding poly(acrylates) with dispersities as low as 1.05 and excellent end group fidelity (>99%). The versatility of the technique is demonstrated by polymerization of methyl acrylate to a range of chain lengths (DP(n) = 25-800) and a number of (meth)acrylate monomers, including macromonomer poly(ethylene glycol) methyl ether acrylate (PEGA480), tert-butyl acrylate, and methyl methacrylate, as well as styrene. Moreover, hydroxyl- and vic-diol-functional initiators are compatible with the polymerization conditions, forming α,ω-heterofunctional poly(acrylates) with unparalleled efficiency and control. The control retained during polymerization is confirmed by MALDI-ToF-MS and exemplified by in situ chain extension upon sequential monomer addition, furnishing higher molecular weight polymers with an observed reduction in dispersity (Đ = 1.03). Similarly, efficient one-pot diblock copolymerization by sequential addition of ethylene glycol methyl ether acrylate and PEGA480 to a poly(methyl acrylate) macroinitiator without prior workup or purification is also reported. Minimal polymerization in the absence of light confers temporal control and alludes to potential application at one of the frontiers of materials chemistry whereby precise spatiotemporal "on/off" control and resolution is desirable.