Modern wearable IoT devices enable the monitoring of vital parameters such as heart or respiratory rates (RESP), electrocardiography (ECG), photo-plethysmographic (PPG) signals within e-health applications. However, a common issue of wearable technology is that signal transmission is powerdemanding and, as such, devices require frequent battery charges and this poses serious limitations to the continuous monitoring of vitals. To ameliorate this, we advocate the use of lossy signal compression as a means to decrease the data size of the gathered biosignals and, in turn, boost the battery life of wearables and allow for fine-grained and long-term monitoring. Considering one dimensional biosignals such as ECG, RESP and PPG, which are often available from commercial wearable IoT devices, we provide a throughout review of existing biosignal compression algorithms and introduce novel approaches based on online dictionaries, elucidating their operating principles and providing a quantitative assessment of their compression, reconstruction and energy consumption performance. As we quantify, the most efficient schemes allow reductions in the signal size of up to 100 times, which entail similar reductions in the energy demand, by still keeping the reconstruction error within 4% of the peak-topeak signal amplitude. Avenues for future research are finally discussed.

Wearable Internet of Things (IoT) devices permit the massive collection of biosignals (e.g., heart-rate, oxygen level, respiration, blood pressure, photo-plethysmographic signal, etc.) at low cost. These, can be used to help address the individual fitness needs of the users and could be exploited within personalized healthcare plans. In this letter, we are concerned with the design of lightweight and efficient algorithms for the lossy compression of these signals. In fact, we underline that compression is a key functionality to improve the lifetime of IoT devices, which are often energy constrained, allowing the optimization of their internal memory space and the efficient transmission of data over their wireless interface. To this end, we advocate the use of autoencoders as an efficient and computationally lightweight means to compress biometric signals. While the presented techniques can be used with any signal showing a certain degree of periodicity, in this letter we apply them to ECG traces, showing quantitative results in terms of compression ratio, reconstruction error and computational complexity. State of the art solutions are also compared with our approach

No abstract

This paper considers a wireless network composed of a pair of sensors powered by energy harvesting devices (EHDs), which transmit data to a receiver over a shared wireless channel. At any given time, based on the energy levels of the two rechargeable batteries of the sensors, a central controller (CC) decides on the amount of energy to be drawn from the two batteries and used for transmission. The problem considered is the maximization of the long-term average reward associated with data transmission, by optimizing the transmission strategy of the two nodes, in the case of a collision channel model and both i.i.d. and correlated energy arrivals. In addition, contrary to the traditional assumption that the amount of energy available to the sensors can be easily estimated, we derive the optimal policy in the cases where the state of charge (SOC) may not be perfectly known by the central controller, analyzing the performance degradation caused by this imperfect knowledge of the SOC. For this second scenario, supposing that the CC is only aware that each SOC is “LOW” or “HIGH,” we show that the impact of imperfect knowledge decreases with the two battery capacities and is negligible in most cases of practical interest

No abstract