Since the turn of the millennium, multi-phase magnetoelectric (ME) composites have been subject to attention and development, and giant ME effects have been found in laminate composites of piezoelectric and magnetostrictive layers. From an application perspective, the practical usefulness of a magnetic sensor is determined not only by the output signal of the sensor in response to an incident magnetic field, but also by the equivalent magnetic noise generated in the absence of such an incident field. Here, a short review of developments in equivalent magnetic noise reduction for ME sensors is presented. This review focuses on internal noise, the analysis of the noise contributions and a summary of noise reduction strategies. Furthermore, external vibration noise is also discussed. The review concludes with an outlook on future possibilities and scientific challenges in the field of ME magnetic sensors.

Articles you may be interested inThe effects of interface misfit strain and surface tension on magnetoelectric effects in layered magnetostrictivepiezoelectric composites J. Appl. Phys. 114, 044109 (2013) In this paper, we discuss a theoretical model with experimental verification for the resonance enhancement of magnetoelectric (ME) interactions at frequencies corresponding to bending-tension oscillations. A dynamic theory of arbitrary laminated magneto-elasto-electric bars was constructed. The model included bending and longitudinal vibration effects for predicting ME coefficients in laminate bar composite structures consisting of magnetostrictive, piezoelectric, and pure elastic layers. The thickness dependence of stress, strain, and magnetic and electric fields within a sample are taken into account, as such the bending deformations should be considered in an applied magnetic or electric field. The frequency dependence of the ME voltage coefficients has obtained by solving electrostatic, magnetostatic, and elastodynamic equations. We consider boundary conditions corresponding to free vibrations at both ends. As a demonstration, our theory for multilayer ME composites was then applied to ferromagnetic-ferroelectric bilayers, specifically Metglas-PZT ones. A theoretical model is presented for static (low-frequency) ME effects in such bilayers. We also performed experiments for these Metglas-PZT bilayers and analyzed the influence of Metglas geometry (length and thickness) and Metglas/PZT volume fraction on the ME coefficient. The frequency dependence of the ME coefficient is also presented for different geometries (length, thickness) of Metglas. The theory shows good agreement with experimental data, even near the resonance frequency. V C 2012 American Institute of Physics.[http://dx

No abstract

We study pull-in instabilities in a functionally graded microelectromechanical system (MEMS) due to the heat produced by the electric current. Material properties of two-phase MEMS are assumed to vary continuously in the thickness direction. It is shown that the pull-in voltage strongly depends upon the variation through the thickness of the volume fractions of the two constituents. It is probably the first work to consider Joule's heating, dependence of the electric conductivity upon the temperature, and the gradation of material properties in studying the pull-in instability in micro-thermoelectro-mechanical plates.

A theoretical model is presented for magnetoelectric (ME) effects in multi-push–pull mode magnetostrictive/piezo-fibre laminate composites. Analytical solutions for the ME coefficient (α ME) were derived. The effects of thickness ratio of the magnetostrictive phase, Kapton and multiple layers of epoxy on the value of α ME were discussed. Experimental results agreed well with the theoretical analysis. When the thickness ratio of the magnetostrictive phase was v = 0.63, α ME was found to have a maximum value of 25.6 V cm−1 Oe−1. For thinner Kapton and epoxy layers, the values of α ME became higher. This model presents theoretical guidelines by which one can achieve higher values of α ME.