Long filament made with nanocellulose has been researched due to its eminent mechanical and physical properties for next generation of natural fiber reinforced polymer composites. Wet spinning process for long filament fabrication in conjunction with stretching method has advantages of high efficiency and low-cost. To fabricate homogeneous and strong cellulose nanofiber filament, this paper experimentally investigates the process parameters, including spinning speed, pre-dry temperature and inner diameter of needle. In addition to the spinning process, a mechanical stretching process is taken into account to further improve the mechanical properties of the cellulose nanofiber filament. The effects of wet spinning and stretching are evaluated by using scanning electron microscope, tensile test and 2D wide angle X-ray diffraction. As a result, the stretched cellulose nanofiber filament exhibits its Young's modulus of 37.5 GPa and tensile strength of 543.1 MPa, which are significantly improved from the previous reports. All about the fabrication process, characterization and evaluation of the cellulose nanofiber filaments are illustrated.

Wood has limitations in strength because of its biostructural defects, including vessels. To overcome this limitation, composite materials can be innovated by breaking wood down into cellulose and lignin and reassembling them for bio‐originating strong structural materials. In this study, an ecofriendly resin was developed that was suitable for cellulose‐based composites. To overcome the low dimensional stability of lignin and to increase its interactions with cellulose, it was blended with poly(vinyl alcohol) (PVA). The PVA–lignin resin was characterized with scanning electron microscopy, Fourier transform infrared spectroscopy, thermal analysis, mechanical tensile testing, and lap‐shear joint testing. The adhesion properties of the PVA–lignin resin increased with increasing PVA content. PVA played the role of synthetic polymer and that of linker between the cellulose and lignin, like hemicellulose does in wood. The PVA–lignin resin exhibited a high miscibility, mechanical toughness, and good adhesion properties for nanocellulose composites. © 2018 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2018, 135, 46655.

Human-made natural-fiber-based filaments are attractive for natural fiber-reinforced polymer (NFRP) composites. However, the composites' moisture distribution is critical, and humidity monitoring in the NFRP composites is essential to secure stability and keep their life span. In this research, high strength and humidity sensing filament was developed by blending cellulose nanofiber (CNF) and graphene oxide (GO), wet-spinning, coagulating, and drying, which can overcome the heterogeneous mechanical properties between embedded-type humidity sensors and NFRP composites. The stabilized synthesis process of the CNF-GO hybrid filament demonstrated the maximum Young's modulus of 23.9 GPa and the maximum tensile strength of 439.4 MPa. Furthermore, the achieved properties were successfully transferred to a continuous fabrication process with an additional stretching process. Furthermore, its humidity sensing behavior is shown by resistivity changes in various temperature and humidity levels. Therefore, this hybrid filament has excellent potential for in-situ humidity monitoring by embedding in smart wearable devices, natural fiber-reinforced polymer composites, and environmental sensing devices.

This article focuses on ethical and policy questions concerning when consent may be sought for the collection and donation of cord blood. It reviews the advantages and disadvantages of alternative times for securing consent, challenges common objections to seeking consent during labor or after collection, and describes a phased consent process--a process that permits consent during early labor to the ex utero collection of cord blood followed by after-consent collection to donation. The phased consent policy attends to the unique characteristics of cord blood collection and donation, respects donors and their families, maximizes the number and diversity of cord blood units collected, preserves the relationship between providers and patients, and preserves public trust in cord blood and other types of tissue banking.