Over the past few decades, removal and recovery of Lanthanum (La) have received great attention due to its significance in different industrial processes. In this review, the application of various adsorbents viz. biosorbents, commercial and hybrid materials, nanoparticles, nanocomposites etc. have been summarized in terms of the removal and recovery of La. The influence of various operating parameters including pH, dosage, contact time, temperature, coexisting ions, adsorption kinetics, isotherm and thermodynamics were investigated. Statistical analysis of the obtained data revealed that 60% and 70% of the authors reported an optimum pH of 4-6 and a dose of 1-2 g/L, respectively. It can be concluded on the basis of an extensive literature survey that the adsorbent materials (especially hybrids nanocomposites) containing carboxyl, hydroxyl and amine groups offered efficient La removal over a wide range of pH with higher adsorption capacity as compared to other adsorbents (e.g., biosorbents and magnetic adsorbents). Also, in most cases, equilibrium and kinetics were followed by Langmuir and pseudo second-order model and adsorption was endothermic in nature. To evaluate the adsorption efficiency of several adsorbents towards La, desorption and regeneration of adsorbents should be given due consideration. The main objective of the review is to provide an insight into the important factors that may affect the recovery of La using various adsorbents.

No abstract

Capacitive deionization (CDI) typically uses one porous carbon electrode that is cation adsorbing and one that is anion adsorbing. In 2016, Smith and Dmello proposed an innovative CDI cell design based on two cation‐selective electrodes and a single anion‐selective membrane, and thereafter this design was experimentally validated by various authors. In this design, anions pass through the membrane once, and desalinated water is continuously produced. In the present work, this idea is extended, and it is experimentally shown that also a choice for anion‐selective electrodes, in combination with a cation‐selective membrane, leads to a functional cell design that continuously desalinates water. Anion‐selective electrodes are obtained by chemical modification of the carbon electrode with (3‐aminopropyl)triethoxysilane. After chemical modification, the activated carbon electrode shows a substantial reduction of the total pore volume and Brunauer–Emmett–Teller (BET) surface area, but nevertheless maintains excellent CDI performance, which is for the first time that a low‐porosity carbon electrode is demonstrated as a promising material for CDI.

No abstract

No abstract