The dynamic features of the low-intermediate-high-(L-I-H) confinement transitions on HL-2A tokamak are presented. Here we report the discovery of two types of limit cycles (dubbed type-Y and type-J), which show opposite temporal ordering between the radial electric field and turbulence intensity. In type-Y, which appears first after an L-I transition, the turbulence grows first, followed by the localized electric field. In contrast, the electric field leads type-J. The turbulence-induced zonal flow and pressure-gradient-induced drift play essential roles in the two types of limit cycles, respectively. The condition of transition between types-Y and -J is studied in terms of the normalized radial electric field. An I-H transition is demonstrated to occur only from type-J.

The turbulence and flows at the plasma edge during the L–I–H, L–I–L and single-step L–H transitions have been measured directly using two reciprocating Langmuir probe systems at the outer midplane with several newly designed probe arrays in the EAST superconducting tokamak. The E × B velocity, turbulence level and turbulent Reynolds stress at ∼1 cm inside the separatrix ramp-up in the last ∼20 ms preceding the single-step L–H transition, but remain nearly constant near the separatrix, indicating an increase in the radial gradients at the plasma edge. The kinetic energy transfer rate from the edge turbulence to the E × B flows is significantly enhanced only in the last ∼10 ms and peaks just prior to the L–H transition. The E × B velocity measured inside the separatrix, which is typically in the electron diamagnetic drift direction in the L-mode, decays towards the ion diamagnetic drift direction in response to fluctuation suppression at the onset of the single-step L–H, L–I–L as well as L–I–H transitions. One important distinction between the L–I–H and the L–I–L transitions has been observed, with respect to the evolution of the edge pressure gradient and mean E × B flow during the I-phase. Both of them ramp up gradually during the L–I–H transition, but change little during the L–I–L transition, which may indicate that a gradual buildup of the edge pedestal and mean E × B flow during the I-phase leads to the final transition into the H-mode. In addition, the transition data in EAST strongly suggest that the divertor pumping capability is an important ingredient in determining the transition behaviour and power threshold.

The recent EAST experimental progress since the last IAEA FEC in 2016 is presented. First demonstration of >100 seconds time scale long-pulse steady-state scenario with a good plasma performance (H98(y2) ~ 1.1) and a good control of impurity and heat exhaust with the tungsten divertor has been successfully achieved on EAST using the pure RF power heating and current drive. The extended operation regimes have been obtained (βP~2.5 & βN~1.9 of using RF&NB and βP~1.9 & βN~1.5). High bootstrap current fraction up to 47% was achieved with q95~6.0-7.0. The interaction effect between the ECH and two LHW systems has been investigated for enhanced current drive and improved confinement quality. ELM suppression using the n= 2 RMPs has been achieved at q95 (≈ 3.2-3.7) with standard type-I ELMy H-mode operational window in EAST. Reduction of the peak heat flux on the divertor was demonstrated using the active radiation feedback control. An increase in the total heating power and improvement of the plasma confinement are expected using a 0-D model prediction for higher bootstrap fraction. Towards long pulse, high bootstrap current fraction operation, a new lower ITER-like tungsten divertor with active watercooling will be installed, together with further increase and improvement of heating and current drive capability.