Nutrient solution temperature in a hydroponic system affects °Brix and yield of lettuce; thus, it is important to maintain the water temperature within an appropriate range. Nutrient-film technique (NFT) trials were conducted to investigate the effects of different water temperatures (18.3 °C, 21.1 °C, and ambient) on growth and °Brix of 17 cultivars from five different types (Loose leaf, Romaine, Butterhead, Salanova, and Batavian) of lettuce. The average daily water temperature for ambient treatment was recorded to be 20 to 26.5 °C. The study was conducted in a split-plot design with three replications over time. Results indicated that water temperature affected root and shoot fresh and dry weight, plant width, and °Brix for lettuce. Lettuce grown at 21.1 °C were 15% greater for shoot fresh weight than plants grown at ambient conditions. All the growth and quality parameters of lettuce were found to be affected by cultivars, with “Coastal Star” showing the best results in both growth and °Brix parameters. All the cultivars of the Romaine type showed greater growth and °Brix, while Salanova lettuce did not perform well in all treatments compared to other lettuce types. For CO2 assimilation, the interaction between water temperature and cultivars was significant, with “Parris Island” having the greatest rate at ambient water temperature. These results suggested that maintaining water temperature at 21.1 °C produced lettuce with greater growth and biomass but had 26% lower °Brix than lettuce grown at 18.3 °C.

Algae is not desirable in hydroponics and creates problems such as reduced yield and decreased dissolved oxygen, and affects the physiology of plants and, thus, needs to be controlled. An experiment was conducted in Ebb and Flow hydroponic systems to investigate the application timing and rates of two hydrogen peroxide products (Zerotol and PERpose Plus). Treatments included 35 mL weekly, 35 mL biweekly, 70 mL weekly, 70 mL biweekly, and a control with no application of hydrogen peroxide using a 40-gallon reservoir of water. Pepper ‘Early Jalapeno’ and ‘Lunchbox Red’ and tomato ‘Geronimo’ and ‘Little Sicily’ were used. The study was conducted in a split-plot design with two replications over time. Plant growth parameters, including plant height, flower number, net CO2 assimilation, fresh weight, and dry weight were recorded. Algae data, including dry weight, algae cell counts, and chl a were also measured. Results indicated that with increasing rate and timing of either product decreased algae counts, dry weight, and chl a values. However, weekly and biweekly application of 70 mL of both products were not different for algae quantification. In pepper, plant height, shoot fresh and dry weight, and root fresh and dry weight were found to be significantly greater with Zerotol 35 mL biweekly, Zerotol 70 mL weekly, PERpose Plus 35 mL biweekly, and PERpose Plus 70 mL weekly compared with the control. ‘Lunchbox Red’ was significantly greater than ‘Early Jalapeno’ in all growth parameters, except soil plant analysis development (SPAD). ‘Lunchbox Red’ had the greatest flower number, with weekly application of 70 mL PERpose Plus. In tomato, greatest flower number and SPAD were observed in ‘Geronimo’ with a weekly application of 70 mL PERpose Plus and 70 mL Zerotol, respectively. Greater shoot and root fresh and dry weight for both tomato cultivars were recorded with 35 mL biweekly or 70 mL weekly application with either product. The results from both plants as well as algae analysis suggest that weekly application of 70 mL of either Zerotol or PERpose Plus produced the best results in terms of controlling algae and improving the growth of pepper and tomato plants.

Cold plasma and ozone sanitation of irrigation solutions can oxidize both microbes and non-target micronutrients because their high oxidation-reduction potential (ORP) is a non-selective mode of action. The objective of this study was to evaluate the effects of cold plasma and ozone treatment on oxidation of iron and manganese in nutrient solutions containing one of four iron chelates (iron-ethylenediaminetetraacetic acid (Fe-EDTA), iron-diethylenetriaminepentaacetic acid (Fe-DTPA), iron-ethylenediamine-N,N′-bis(2-hydroxyphenylacetic acid) (Fe-EDDHA), and hydroxybenzyl ethylenediamine (Fe-HBED)). Nutrient solutions were recirculated through the cold plasma or ozone system until the ORP reached 700 mV. The concentrations of total dissolved iron, manganese, and chelated iron were measured before and after passing through the treatment systems. Both cold plasma and ozone oxidized chelates and decreased the solubility of iron and manganese. Cold plasma and ozone had similar effects on micronutrients, pH, electrical conductivity, and dissolved oxygen at a standardized target ORP of 700 mV. Fe-EDTA was the most resistant chelate to oxidation. With Fe-EDTA, ORP increased more quickly, and the concentration of chelated Fe decreased less with the increasing ORP over time compared with Fe-DTPA, Fe-EDDHA, and Fe-HBED. The concentration of chelated Fe decreased by up to 80% for EDDHA at 700 mV compared with a 20% decrease for EDTA. The concentration of Mn decreased by up to 85% at 700 mV. The design of water treatment with cold plasma or ozone therefore requires consideration of secondary effects on micronutrients. The treatment dosage, flow rate, and nutrient solution at a particular grower operation are likely to affect the quantity of micronutrient fertilizer that needs to be supplemented following treatment. Use of Fe-EDTA is one strategy to reduce the loss of iron and increase residual ORP that is available for sanitation.