No abstract

No abstract

Silica nanoparticles were dispersed in an aqueous emulsion of alkoxy silanes and organic fluoropolymer. The dispersion was sprayed onto white marble and sandstone. The deposited composite coatings exhibited (i) superhydrophobicity and superoleophobicity, as evidenced by the high (>150°) static contact angles of water and oil drops as well as (ii) water and oil repellency according to the low (<7°) corresponding tilt contact angles. Apart from marble and sandstone, the coatings with extreme wetting properties were deposited onto concrete, silk, and paper, thus demonstrating the versatility of the method. The siloxane/fluoropolymer product was characterized using Fourier Transform Infrared Spectroscopy (FT-IR), Raman spectroscopy and Scanning Electron Microscopy equipped with an Energy Dispersive X-ray Spectrometer (SEM-EDX). Moreover, SEM and FT-IR were used to reveal the surface structures of the composite coatings and their transition from superhydrophobicity to superhydrophilicity which occurred after severe thermal treatment. The composite coatings slightly reduced the breathability of marble and sandstone and had practically no optical effect on the colour of the two stones. Moreover, the coatings offered good protection against water penetration by capillarity.

No abstract

Silica nanoparticles (7 nm) were dispersed in solutions of a silane/siloxane mixture. The dispersions were applied, by brush, on four types of paper: (i) modern, unprinted (blank) paper, (ii) modern paper where a text was printed using a common laser jet printer, (iii) a handmade paper sheet detached from an old book, and (iv) Japanese tissue paper. It is shown that superhydrophobicity and water repellency were achieved on the surface of the deposited films, when high particle concentrations were used (≥1% w/v), corresponding to high static (θS≈ 162°) and low tilt (θt< 3°) contact angles. To interpret these results, scanning electron microscopy (SEM) was employed to observe the surface morphologies of the siloxane-nanoparticle films. Static contact angles, measured on surfaces that were prepared from dilute dispersions (particle concentration <1% w/v), increased with particle concentration and attained a maximum value (162°) which corresponds to superhydrophobicity. Increasing further the particle concentration did not have any effect onθS. Colourimetric measurements showed that the superhydrophobic films had negligible effects on the aesthetic appearance of the treated papers. Furthermore, it is shown that the superhydrophobic character of the siloxane-nanoparticle films was stable over a wide range of pH.