This research presents the flexural behavior on reinforced concrete beam with transverse web opening constructed from layered concrete. The layered concrete combining normal concrete and lightweight aggregate concrete (LWC) are depended in present study. In the experimental program, 13 models of normal and layered reinforced concrete beams are tested under the effect of four-point loads. All beams had the same overall geometrical dimensions and main longitudinal top and bottom with internal diagonal reinforcement provided around the openings.  One of the beam specimen is tested as control beam and the other specimens are divided into three groups [G1, G2, and G3] to study the effects of the following variables: effect of presence of web openings, layered system, lightweight aggregate (partially volumetric replacement of normal aggregate by thermostone) on the ultimate load, cracking load, cracking pattern and energy absorption capacity. The existing of an opening in beam specimens reduced the flexural capacity of beams with a percentage depending on the size of opening and opening number. The test data obtained from the adopted layered technique of (NEW) and (LWC) have shown that for beams constructed from two layered concrete (LWC with thermostone in the web and bottom flange of I-beam section) ultimate load is decreased about (9.3%-48.8%). It has also, the beams constructed from three-layered of concrete (LWC with thermostone in the web of I-beam section), their ultimate load is decreased about (25.6%-58.1%). On the other hand, magnitude increased of energy absorption capacity are achieved by the decreased opening size, introducing the full size opening of dimension (100×1000) mm reduces the energy absorption capacity of the RC I-section beams at least 80% compared to solid beam while the beam with opening size (100×100) mm decrease up to 16%. In the case of the layered concrete beams specimen, the real influence of lightweight concrete (LWC) type in the layered reinforced concrete is observed significantly after increasing the length of opening more than 100 mm.

This research presents an experimental investigation of the rehabilitation efficiency of the damaged hybrid reinforced concrete beams with openings in the shear region. The study investigates the difference in retrofitting ability of hybrid beams compared to traditional beams and the effect of two openings compared with one opening equalized to two holes in the area. Five RC beams classified into two groups, A and B, were primarily tested to full-failure under two-point loads. The first group (A) contained beams with normal weight concrete. The second group (hybrid) included beams with lightweight concrete for web and bottom flange, whereas the top flange was made from normal concrete. Two types of openings were considered in this study, rectangular, with dimensions of 100×200 mm, and two square openings with a side dimension of 100 mm. A full wrapping configuration system for the shear region (failure zone) was adopted in this research. Based on the test results, the repaired beams managed to recover their load carrying capacity, stiffness, and structural performance in different degrees. The normal concrete beam regains its total capacity for all types of openings, while the hybrid beams gain 84% of their strength. The strength of hybrid concrete members compared with normal concrete is 81 and 88% for beams of one opening and two openings, respectively. Doi: 10.28991/CEJ-2022-08-01-012 Full Text: PDF