Long-term photovoltaic (PV) module reliability is highly determined by the durability of the polymeric components (backsheet and encapsulation materials). This paper presents the result of experiments on encapsulant degradation influenced by the backsheet permeation properties. Towards this goal, one type of ethylene/vinyl acetate copolymer (EVA) was aged in glass/EVA/backsheet laminates in accelerated aging tests (up to 4000 h for Damp-Heat (DH) and up to 480 kWh/m2 for UV and UV-DH combined). The samples contained three backsheets with different permeation properties to examine their impact on EVA degradation. Thermal and chemical characterization shows that the EVA degradation is stronger with the glass–EVA–polyamide (PA)-based backsheet than with the polyethylene terephthalate (PET)-based backsheets. The higher oxygen transmission rate (OTR) of the PA-based backsheet may increase photo-oxidation and aggravating the degradation of EVA in the laminates. Furthermore, FTIR results were used to demonstrate the effect of damp heat exposure on the EVA interfaces, showing an accelerated degradation at the glass–EVA interface. The comparison of accelerated aging stress factors reveals that EVA suffers the strongest chemical and optical degradation when high UV, high temperature and high relative humidity are combined simultaneously.

The power degradation and failure of photovoltaic (PV) modules can be caused by changes in the mechanical properties of the polymeric components during the module lifetime. This paper introduces instrumented nanoindentation as a method to investigate the mechanical properties of module materials such as polymeric encapsulants. To this end, nanoindentation tests were carried out on ethylene vinyl acetate (EVA) surfaces, which have been separated from the glass panel. Two types of time-dependent indentation cycle modes, the time domain (creep mode) and frequency domain (dynamic mode) were performed to determine the viscoelastic behavior. For each mode, a corresponding model was applied to calculate the main mechanical properties. The general capability of nanoindentation as cross-linking determination method is investigated with the methodological advantages over bulk mechanical characterization methods. A large number of Glass/EVA/Backsheet laminates were built using different lamination conditions resulting in different degrees of curing. Both indentation modes indicate good modulus sensitivity for following the EVA crosslinking in its early stages but could not reliably differentiate between samples with higher EVA branching. Additional dynamic mechanical analysis (DMA) characterization was used as an established method to validate the indentation measurements. Both nanoindentation and DMA tensile mode produce similar quantitative viscoelastic responses, in the form of the damping factor parameter, demonstrated for three different frequencies at room temperature. A statistical study of the data reveals the advantages for the investigation of multilayer PV laminates by using nanoindenation as a surface method while also being applicable to field aged modules.

The characterization of mechanical properties of polymeric backsheet and encapsulation foils of photovoltaic (PV) modules usually involves destructive techniques, such as dynamic mechanical analysis and tensile testing. In this article, we validate the scanning acoustic microscopy (SAM) as a nondestructive characterization method to estimate the mechanical properties of polymeric multi‐layers in PV modules. The acoustic speed inside each individual material is measured and its mechanical properties calculated. For this validation, other techniques are employed to determine the values of density, thickness, and elastic modulus of the foils. The viscoelastic properties of the polymeric foils are temperature dependent. The longitudinal modulus measured acoustically at 15 MHz and the Young's modulus from conventional tensile testing were compared at different temperatures. Both techniques show good agreement regarding the change in mechanical properties caused by temperature variation. The disagreement in the absolute values of these parameters is explained by the different frequency magnitudes at which both measurements are performed. This confirms that SAM is a reliable technique to measure changes in the viscoelastic properties of the foils in PV modules nondestructively, and thus to obtain more information about aging‐induced material changes and degradation.