i) The problem: to measure T e as high as 40 keV using Thomson Scattering in the reactor core both for Maxwellian and non-Maxwellian case of electron velocity distribution function especially in the case of unknown system spectral responsivity. (ii) The suggested solutions:to use IR probing laser 1320 nm additionally to convenient NIR laser 1064 nm to improve measurement accuracy for T e~ 40keV;to use specific algorithm for TS data processing in case of non-Maxwellian eVDF; to use multi-laser approach, that suggests plasma probing with 3 lasers -946 nm/1064 nm/1320 nm simultaneously in the case of unknown system spectral sensitivity.(iii) Next steps -test multi-laser approach and designed data procession technique in real experiment on existing fusion device.

Almost all optical diagnostic systems in ITER will require the implementation of mirror recovery and protection systems. Plasma cleaning is considered to be the most promising technique for the removal of metal deposits from optical surfaces. The engineering and physical aspects of RF discharge application for continuous or periodic plasma treatment are discussed with a focus on implementation under ITER conditions. The ion flux parameters obtained in capacitively coupled (CC) RF discharge were measured in the mock-up of a plasma cleaning system. The uniformity of sputtering in CC RF discharge with and without a magnetic field was studied experimentally for the cylindrical discharge reactor geometry and compared with numerical simulations. The sharp increase in the sputtering rate resulting from the non-uniform radial distribution of the ion flux was observed near the electrode edges. The longitudinal magnetic field improves sputtering uniformity. It was demonstrated that Al/Al 2 O 3 deposits can be removed in the Ne and D 2 plasma of CC RF discharge but longterm exposition results in the degradation of the polycrystalline molybdenum mirror surface. The efficiency of Al sputtering in the atmosphere containing O 2 and N 2 fractions was studied in the D 2 /O 2 and D 2 /N 2 plasma of glow discharge. The addition of 2% of oxygen or nitrogen increases the sputtering yield by 3-4 times as compared with that in a nominally pure D 2 discharge. The impact of metal deposits on the performance of diagnostic mirrors is discussed. It was shown that an ultrathin metallic film with a thickness as low as a few nm may cause a significant degradation of diagnostic mirrors with a transparent coating.

No abstract

No abstract

Divertor Thomson scattering (DTS) and laser-induced fluorescence (LIF) are both laser aided diagnostics well suited to combination with common probing and collecting optics that are the most sophisticated and expensive part of any ITER optical diagnostic system. The combination of DTS and LIF are used for simultaneous measurement of local electron (Te, ne), ion (Ti, nHeII) and atom (nHeI, nH(D,T)) parameters and provide basic information on rates of electron and ion processes to allow basic understanding of the physics of divertor plasma detachment. The measured parameters permit the calculation of rates of ionization and recombination using Te, ne, Ti, ni, nHeI and nH(D,T); emission intensity—Te, ne, ni, nHeI and nH(D,T); frictional force of the plasma flow due to collisions with neutrals—Ti, ni, T0, nHeI and nH(D,T) and pressure of the incoming plasma flow—Te, ne, Ti and ni. The paper discusses the benefits of DTS and LIF integration, suggests new approaches to the estimation of DTS capability, LIF implementation and possibilities for further diagnostic development.