The progressive damage and subsequent demolition of unreinforced masonry (URM) buildings arising from the Canterbury earthquake sequence is reported. A dataset was compiled of all URM buildings located within the Christchurch CBD, including information on location, building characteristics, and damage levels after each major earthquake in this sequence. A general description of the overall damage and the hazard to both building occupants and to nearby pedestrians due to debris falling from URM buildings is presented with several case study buildings used to describe the accumulation of damage over the earthquake sequence. The benefit of seismic improvement techniques that had been installed to URM buildings is shown by the reduced damage ratios reported for increased levels of retrofit. Demolition statistics for URM buildings in the Christchurch CBD are also reported and discussed.

As part of the ‘Project Masonry’ Recovery Project funded by the New Zealand Natural Hazards Research Platform, commencing in March 2011, an international team of researchers was deployed to document and interpret the observed earthquake damage to masonry buildings and to churches as a result of the 22nd February 2011 Christchurch earthquake. The study focused on investigating commonly encountered failure patterns and collapse mechanisms. A brief summary of activities undertaken is presented, detailing the observations that were made on the performance of and the deficiencies that contributed to the damage to approximately 650 inspected unreinforced clay brick masonry (URM) buildings, to 90 unreinforced stone masonry buildings, to 342 reinforced concrete masonry (RCM) buildings, to 112 churches in the Canterbury region, and to just under 1100 residential dwellings having external masonry veneer cladding. In addition, details are provided of retrofit techniques that were implemented within relevant Christchurch URM buildings prior to the 22nd February earthquake and brief suggestions are provided regarding appropriate seismic retrofit and remediation techniques for stone masonry buildings.

The 2016 Kaikoura earthquake resulted in shaking in excess of design level demands for buildings with periods of 1-2s at some locations in Wellington. This period range correlated to concrete moment frame buildings of 5-15 storeys, many of which had been built in Wellington since the early 1980s, and often with precast concrete floor units. The critical damage states used to assess buildings during the Wellington City Council Targeted Assessment Programme are described and examples of observed damage correlating to these damage states are presented. Varying degrees of beam hinging were observed, most of which are not expected to reduce the frame capacity significantly. Buildings exhibiting varying degrees of residual beam elongation were observed. Cases of significant beam elongation and associated support beam rotation resulted in damage to precast floor unit supports; in one case leading to loss of support for double-tee units. The deformation demands also resulted in damage to floor diaphragms, especially those with hollowcore floor units. Cracking in floor diaphragms was commonly concentrated in the corners of the building, but hollowcore damage was observed both at the corners and in other locations throughout several buildings. Transverse cracking of hollowcore floor units was identified as a particular concern. In some cases, transverse cracks occurred close to the support, as is consistent with previous research on hollowcore floor unit failure modes. However, transverse cracks were also observed further away from the support, which is more difficult to assess in terms of severity and residual capacity. Following the identification of typical damage, attention has shifted to assessment, repair, and retrofit strategies. Additional research may be required to determine the reduced capacity of cracked hollowcore floor units and verify commonly adopted repair and retrofit strategies.

No abstract

No abstract