No abstract

In recent decades, polymer composites have gained significant interests within the research community due to its high strength-to-weight ratio. Its properties, such as low cost, lightweight, corrosion resistance, and impact resistance, make it desirable for both household and industrial applications. However, the reliability of the composite model with density influence is still challenging. In this study, experiments were carried out using epoxy systems of varying densities to fabricate oil palm empty fruit bunch (OPEFB) carbon nanoparticle composites to investigate the influence of matrix density on its Weibull modulus. It is found that the increase in matrix density increases the nanocomposite reliability. A Weibull modulus of 9.5, 82.2 and 183.4 were obtained for low, medium and high matrix density nanocomposites, respectively. Such findings would facilitate the development of particle-reinforced composites.

Numerous literatures have suggested that the use of natural fiber as filler can improve the mechanical properties of a polymer composite. Oil palm empty fruit bunch fibers (OPEFB) are no exception and have shown to exhibit good mechanical properties, with the potential to produce environmentally friendlier composites. In this study, the tensile strengths and morphologies of micro OPEFB filled composites with varying loadings (0.3125 wt% to 10 wt%) were investigated. It was found that increasing content of OPEFB reduces the translucency of the composite almost linearly. It was also revealed that the addition of 0.3125 wt% to 2.5 wt% has a reinforcing effect, observing improvement up to 17.4% compared to its neat condition. Such findings would facilitate the development of an effective OPEFB reinforced polymeric nanocomposite.

During the composite’s fabrication process, one of the most common defect occurs is void. Numerous literatures have suggested that the presence of void negatively affect its mechanical properties and effective degassing process is one the solutions for such issue. In this study, experiments were carried out using neat E132 epoxy to investigate the effects of different degassing process (hot water, ultrasonic bath, and vacuum) on its tensile strength. The duration of its process was carried out from 5 – 9 minutes for hot water and ultrasonic bath where vacuum process was extended until 10 minutes to observed limiting behavior. It is found that the vacuum degassing method is the most effective. Vacuum degassing process displayed the least formation of bubble and micro voids even for 10 minutes. It is also revealed that vacuum degassing process resulted the highest average tensile strength at 48.8MPa. Such findings would facilitate the well bonded effective nanocomposite fabrication process.