This study designed an externally pressurized bearing and analyzed the rotordynamics of a turbo expander for a hydrogen liquefaction plant. The turbo expander, comprising a turbine and compressor wheel assembled to a shaft, lowered the temperature of the helium refrigerant. Its rated speed was 75,000 rpm, and an externally pressurized gas bearing was selected to support the rotor. Pressurized helium was used as the lubricant for the bearing operation. To design the rotor–bearing system, we conducted a bearing performance analysis and rotordynamic characteristic prediction using the developed numerical model. We calculated the bearing stiffness and flow rate of the bearing gas for various feed parameters and selected the appropriate orifice diameter for maximum stiffness. The predicted Campbell diagram showed that the system had a sufficient separation margin with the critical speed, and the predicted critical speed correlated well with the nonlinear orbit simulation. A successful operation was achieved with the manufactured turbo expander within the rated speed. The shaft vibration was monitored during the operation test, and the test results revealed two critical speeds below the rated speed, as predicted by the analytical model. In addition, the shaft vibration was maintained at <3 μm.

A design process for cryogenic expanders that supplies 0.5 TPD of liquefied hydrogen in hydrogen liquefaction plants is introduced. To improve the efficiency of the expander, the optimum design was conducted by adjusting two rotor shape parameters. The designed expander for hydrogen liquefaction has a target rotation speed of 75,000 rpm, and helium is applied as the working fluid. Since the operating temperature of the expander is as low as 49 K, a design that reflects the real gas properties must be considered. For a high-efficiency hydrogen liquefaction plant, increasing the expander efficiency is one of the most critical issues. In this study, the efficiency of the cryogenic expander was optimized using the response surface method (RSM). The hub and shroud meridional contours and blade β angle distributions were chosen as the design parameters. As a result, through the optimized design, it was possible to improve the expander efficiency by up to 1.98% compared to the original expander. Flow analysis was conducted to investigate the reason for the efficiency improvement. Through this study, the effect of the blade meridional contour and blade β angle on the cryogenic expander efficiency was verified.

The turbomachinery used in the sCO2 power cycle requires a high stable rotor-bearing system because they are usually designed to operate in extremely high-pressure and temperature conditions. In this paper, we present a pump-drive turbine module applying hydrostatic bearing using liquid CO2 as the lubricant for a 250 kW supercritical CO2 power cycle. This design is quite favorable because stable operation is possible due to the high stiffness and damping of the hydrostatic bearing, and the oil purity system is not necessary when using liquid CO2 as the lubricant. The pump-drive turbine module was designed to operate at 21,000 rpm with the rated power of 143 kW. The high-pressure liquid CO2 was supplied to the bearing, and the orifice restrictor was used for the flow control device. We selected the orifice diameter providing the maximum bearing stiffness and also conducted a rotordynamic performance prediction based on the designed pump-drive turbine module. The predicted Campbell diagram indicates that a wide range of operation is possible because there is no critical speed below the rated speed. In addition, an operation test was conducted for the manufactured pump-drive turbine module in the supercritical CO2 cycle test loop. During the operation, the pressurized CO2 of the 70 bar was supplied to the bearing for the lubrication and the shaft vibration was monitored. The successful operation was possible up to the rated speed and the test results showed that shaft vibration is controlled at the level of 2 μm for the entire speed range.