PurposeMechanical issues related to the information and growth of small cracks are considered to play a major role in very high cycle fatigue (VHCF) for metallic materials. Further efforts on better understanding in early stage of a crack are beneficial to estimating and preventing catastrophic damage for a long period service.Design/methodology/approachDependent on the ultrasonic loading system, a novel method of in situ photomicroscope is established to study the crack behaviors in VHCF regime.FindingsThis in situ photomicroscope method provides advantages in combination with fatigue damage monitoring at high magnification, a large number of cycles, and efficiency. Visional investigation with attached image proceeding code proves that the method has high resolution on both size and time, which permits reliable accuracy on small crack growth rate. It is observed that the crack propagation trends slower in the overall small crack stage down to the level of 10–11 m/cycle. Strain analysis relays on a real-time recording which is applied by using digital image correlation. Infrared camera recording indicates the method is also suitable for thermodynamic study while growth of damage.Originality/valueBenefiting from this method, it is more convenient and efficient to study the short crack propagation in VHCF regime.

The very high cycle fatigue (VHCF) failure of in-service components is mainly caused by the vibration of thin-wall elements at a high frequency. In this work, a novel model of ultrasonic fatigue test was developed to test thin-wall material in bending up to VHCF with an accelerated frequency. The theoretical principle and finite element analysis were introduced for designing a sample that resonated at the frequency of 20 kHz in flexural vibration. In the advantage of the second-order flexural vibration, the gauge section of the sample was in the pure bending condition which prevented the intricate stress condition for thin-wall material as in the root of cantilever or the contact point of three points bending. Moreover, combining the constraint and the loading contact in one small section significantly reduced heating that originated from the friction at an ultrasonic frequency. Both strain gauge and deflection angle methods were applied to verify the controlling of stress amplitude. The fractography observation on Ti6Al4V samples indicated that the characterized fracture obtained from the novel model was the same as that from the conventional bending test.

The very high cycle fatigue (VHCF) problems of thin-plate structures are usually caused by high-frequency vibrations. This paper proposes an accelerated fatigue test method based on ultrasonic loading technology in order to develop a feasible bending testing method and explore the bending fatigue characteristics of thin-plate structures in the VHCF regime. A new bending fatigue specimen with an intrinsic frequency of 20 kHz was designed based on cantilever bending through finite element simulation. It was verified by the axial load test with R = −1. The results showed that the method could effectively transfer the dangerous cross-section at the first-order cantilever bending restraint to the internal part of the specimen, thereby making the fracture location independent of the complex stresses. The linear relationship between the vibration amplitude and the maximum stress was also verified using strain measurements. Furthermore, the S-N curves and fracture morphology for different loading types were consistent with conventional studies to a certain extent, which indicated that the design of the bending test model was reasonable.