A revised morphological model for the crimp structure of tendon is presented. The 300-500 mu diameter tendons of the mature rat tail are comprised of from one to more than ten substructures, called fascicles, of 80-320 mu diameter. Fascicles each possess a "crimp structure" demonstrable in the polarizing microscope and neighboring fascicles within a tendon usually exhibit crimp registry. The fascicle itself is shown to be a cylindrical array of planar-zig-zag crimped 500-5000 A diameter collagen fibrils. The approximate cylindrical symmetry of the fascicle is domonstrated by SEM not equal to and polarizing optical microscopy. A method of replacing native water with other liquids of refractive index near to that of collagen is utilized to reduce or eliminate light diffusion and therby greatly improve OM observations. Small bunches of collagen fibrils removed from the tendon are shown to exhibit the simple planar zig-zag morphology described in previous literature. The planar crimping of collagen fibrils and their assemblage into cylindrically symmetric fascicles is verified by small angle X-ray diffraction.

Ethylene‐octene copolymers prepared by Dow's INSITE™ constrained geometry catalyst technology present a broad range of solid‐state structures from highly crystalline, lamellar morphologies to the granular morphology of low crystallinity copolymers. As the comonomer content increases, the accompanying tensile behavior changes from necking and cold drawing typical of a semicrystalline thermoplastic to uniform drawing and high recovery characteristic of an elastomer. Although changes in morphological features and tensile properties occur gradually with increasing comonomer content, the combined body of observations from melting behavior, morphology, dynamic mechanical response, yielding, and large‐scale deformation suggest a classification scheme with four distinct categories. Materials with densities higher than 0.93 g/cc, type IV, exhibit a lamellar morphology with well‐developed spherulitic superstructure. Type III polymers with densities between 0.93 and 0.91 g/cc have thinner lamellae and smaller spherulites. Type II materials with densities between 0.91 and 0.89 g/cc have a mixed morphology of small lamellae and bundled crystals. These materials can form very small spherulites. Type I copolymers with densities less than 0.89 g/cc have no lamellae or spherulites. Fringed micellar or bundled crystals are inferred from the low degree of crystallinity, the low melting temperature, and the granular, nonlamellar morphology. © 1996 John Wiley & Sons, Inc.

The design and fabrication of ultrathin polymer layers are of increasing importance because of the rapid development of nanoscience and nanotechnology. Confined, two-dimensional crystallization of polymers presents challenges and opportunities due to the long-chain, covalently bonded nature of the macromolecule. Using an innovative layer-multiplying coextrusion process to obtain assemblies with thousands of polymer nanolayers, we discovered a morphology that emerges as confined polyethylene oxide (PEO) layers are made progressively thinner. When the thickness is confined to 20 nanometers, the PEO crystallizes as single, high-aspect-ratio lamellae that resemble single crystals. Unexpectedly, the crystallization habit imparts two orders of magnitude reduction in the gas permeability.