No abstract

.[1] Mid-ocean ridge transform faults (RTFs) vary strongly along strike in their ability to generate large earthquakes. This general observation suggests that local variations in material properties along RTFs exert a primary control on earthquake rupture dynamics. We explore these relationships by examining the seismic structure of two RTFs that have distinctly different seismic coupling. We determine the seismic velocity structure at the Gofar and Quebrada faults on the East Pacific Rise (EPR) using P wave traveltime tomography with data from two active-source wide-angle refraction lines crossing the faults. We image low-velocity zones (LVZs) at both faults, where P wave velocities are reduced by as much as 0.5-1.0 km/s ($10-20%) within a several kilometer wide region. At the Gofar fault, the LVZ extends through the entire crust, into the seismogenic zone. We rule out widespread serpentinization as an explanation for the low velocities, owing to the lack of a corresponding signal in the locally measured gravity field. The reduced velocities can be explained if the plate boundary region is composed of fault material with enhanced fluid-filled porosity (1.5-8%). Local seismic observations indicate that the high-porosity region lies within a $10 km long portion of the fault that fails in large swarms of microearthquakes and acts as a barrier to the propagation of large (M $ 6.0) earthquakes. Tomographic images of fault structure combined with observed earthquake behavior suggest that EPR transform segments capable of generating large earthquakes have relatively intact gabbro within the seismogenic zone, whereas segments that slip aseismically or via earthquake swarms are composed of highly fractured, ≥2 km wide damage zones that extend throughout the crust.

S U M M A R YSwarm-like earthquake sequences are commonly observed in a diverse range of geological settings including volcanic and geothermal regions as well as along transform plate boundaries. They typically lack a clear mainshock, cover an unusually large spatial area relative to their total seismic moment release, and fail to decay in time according to standard aftershock scaling laws. Swarms often result from a clear driving phenomenon, such as a magma intrusion, but most lack the necessary geophysical data to constrain their driving process. To identify the mechanisms that cause swarms on strike-slip faults, we use relative earthquake locations to quantify the spatial and temporal characteristics of swarms along Southern California and East Pacific Rise transform faults. Swarms in these regions exhibit distinctive characteristics, including a relatively narrow range of hypocentral migration velocities, on the order of a kilometre per hour. This rate corresponds to the rupture propagation velocity of shallow creep transients that are sometimes observed geodetically in conjunction with swarms, and is significantly faster than the earthquake migration rates typically associated with fluid diffusion. The uniformity of migration rates and low effective stress drops observed here suggest that shallow aseismic creep transients are the primary process driving swarms on strike-slip faults. Moreover, the migration rates are consistent with laboratory values of the rate-state friction parameter b (0.01) as long as the Salton Trough faults fail under hydrostatic conditions.