No abstract

No abstract

A resonator system has been fabricated directly on a pre-processed CMOS chip. The system is to be used for high sensitivity mass sensing applications in air and vacuum. The resonator system, corresponding of a cantilever and structures for electrostatic actuation and capacitive read-out, have been defined by electron beam lithography on top of a charge and radiation sensitive CMOS layer in predefined areas as a post-process step. This has been accomplished without affecting the electronic properties of the pre-processed CMOS circuits. The subsequent etching steps to fully release the cantilevers have been obtained without stiction of the cantilevers to the substrate. Cantilevers are driven at their mechanical resonance in a lateral mode, and the frequency is monitored by capacitive read-out on the chip. CMOS integration enables signal detection directly on the chip, which radically decreases the parasitic capacitances. Consequently, low-noise electrical measurements with a very high mass sensitivity are obtained. Fabricated resonator systems were characterized to have resonance frequencies of approximately 1.49 MHz, which is in good agreement with a theoretical estimation of 1.41 MHz. The theoretical mass resolution, ∂m/∂ f , is approximately 17 ag Hz −1 , using a Young modulus value of 160 GPa.

No abstract

A CMOS compatible direct write laser lithography technique has been developed for cantilever fabrication on pre-fabricated standard CMOS. We have developed cantilever based sensors for mass measurements in vacuum and air. The cantilever is actuated into lateral vibration by electrostatic excitation and the resonant frequency is detected by capacitive readout. The device is integrated on standard CMOS circuitry. In the work a new direct write laser lithography (DWL) technique is introduced. This laser lithography technique is based on direct laser writing on substrates coated with a resist bi-layer consisting of poly(methyl methacrylate) (PMMA) on lift-off resist (LOR). Laser writing evaporates the PMMA, exposing the LOR. A resist solvent is used to transfer the pattern down to the substrate. Metal lift-off followed by reactive ion etching is used for patterning the structural poly-Si layer in the CMOS. The developed laser lithography technique is compatible with resist exposure techniques such as electron beam lithography. We demonstrate the fabrication of sub-micrometre wide suspended cantilevers as well as metal lift-off with feature line widths down to approximately 500 nm.