No abstract

A monolithic microchannel-cooled laser diode array is demonstrated that allows multiple diode-bar mounting with negligible thermal cross talk. The heat sink comprises two main components: a wet-etched Si layer that is anodically bonded to a machined glass block. The continuous wave (cw) thermal resistance of the 10 bar diode array is 0.032 °C/W, which matches the performance of discrete microchannel-cooled arrays. Up to 1.5 kW/cm2 is achieved cw at an emission wavelength of ∼808 nm. Collimation of a diode array using a monolithic lens frame produced a 7.5 mrad divergence angle by a single active alignment. This diode array offers high average power/brightness in a simple, rugged, scalable architecture that is suitable for large two-dimensional areas.

Several techniques have been developed to phase apertures in the context of astronomical telescopes with segmented mirrors. Phasing multiple apertures, however, is important in a wide range of optical applications. The application of primary interest in this paper is the phasing of multiple short pulse laser beams for fast ignition fusion experiments. In this paper analytic expressions are derived for parameters such as the far-field distribution, a line-integrated form of the far-field distribution that could be fit to measured data, enclosed energy or energy-in-a-bucket and center-of-mass that can then be used to phase two rectangular apertures. Experimental data is taken with a MEMS device to simulate the two apertures and comparisons are made between the analytic parameters and those derived from the measurements. Two methods, fitting the measured far-field distribution to the theoretical distribution and measuring the ensquared energy in the far-field, produced overall phase variance between the 100 measurements of less than 0.005 rad(2) or an RMS displacement of less than 12 nm.

We report on

Operation of the Mercury laser with two amplifiers activated has yielded 30 Joules at 1 Hz and 12 Joules at 10 Hz and over 8x10 4 shots on the system. Static distortions in the Yb:S-FAP amplifiers were corrected by magneto rheological finishing technique.2004 Optical Society of America