No abstract

The progressive development of a micro-fluidic manifold for the chemiluminescent detection of copper in water samples, based on the measurement of light emitted from the Cu(ii) catalysed oxidation of 1,10-phenanthroline by hydrogen peroxide, is reported. Micro-fluidic manifolds were designed and manufactured from polymethylmethacrylate (PMMA) using three micro-fabrication techniques, namely hot embossing, laser ablation and direct micro-milling. The final laser ablated design incorporated a reagent mixing channel of dimensions 7.3 cm in length and 250 x 250 microm in width and depth (triangular cross section), and a detection channel of 2.1 cm in length and 250 x 250 microm in width and depth (total approx. volume of between 16 to 22 microL). Optimised reagents conditions were found to be 0.07 mM 1,10-phenanthroline, containing 0.10 M cetyltrimethylammonium bromide and 0.075 M sodium hydroxide (reagent 1 delivered at 0.025 mL min(-1)) and 5% hydrogen peroxide (reagent 2 delivered at 0.025 mL min(-1)). The sample stream was mixed with reagent 1 in the mixing channel and subsequently mixed with reagent 2 at the start of the detection channel. The laser ablated manifold was found to give a linear response (R(2) = 0.998) over the concentration ranges 0-150 microg L(-1) and be reproducible (% RSD = 3.4 for five repeat injections of a 75 microg L(-1) std). Detection limits for Cu(ii) were found to be 20 microg L(-1). Selectivity was investigated using a copper selective mini-chelating column, which showed common cations found in drinking waters did not cause interference with the detection of Cu(ii). Finally the optimised system was successfully used for trace Cu(ii) determinations in a standard reference freshwater sample (SRM 1640).

No abstract

No abstract

Original PaperColumn selection for comprehensive multidimensional ion chromatography This paper discusses the selection of ion chromatography (IC) columns for use in comprehensive multidimensional ion chromatography (IC6IC). First, a single number was determined for a wide range of anions (one number for each anion) using the linear solvent strength model. These numbers were then used to compare the column selectivity characteristics for five different columns. Principal component analysis was used to illustrate selectivity differences between columns. Dionex AS16 and AS20 columns were selected for use in the development of an IC6IC method for the separation of ten anions. To achieve the required speed of analysis in both the first and second separation dimensions, custom column lengths were packed inhouse. The use of an eluent suppressor between the first and second columns permits a relatively low flow ratio regime of only a1:20 in the first and second dimensions, respectively, which reduces dilution effects common in comprehensive multidimensional LC. Selection of the second dimension eluent conditions was aided by the development of a spreadsheet based on the linear solvent strength model.