Supernumerary teeth (ST) are odontostomatologic anomaly characterized by as the existence excessive number of teeth in relation to the normal dental formula. This condition is commonly seen with several congenital genetic disorders such as Gardner's syndrome, cleidocranial dysostosis and cleft lip and palate. Less common syndromes that are associated with ST are; Fabry Disease, Ellis-van Creveld syndrome, Nance-Horan syndrome, Rubinstein-Taybi Syndrome and Trico–Rhino–Phalangeal syndrome. ST can be an important component of a distinctive disorder and an important clue for early diagnosis. Certainly early detecting the abnormalities gives us to make correct management of the patient and also it is important for making well-informed decisions about long-term medical care and treatment. In this review, the genetic syndromes that are related with ST were discussed.

No abstract

The aim of this study was to evaluate temperature changes in the pulp chamber during polymerization of four different pulp-capping materials using a LED-light-curing-unit in the contact and noncontact positions. A pulpal circulation mechanism was simulated to measure increases in temperature in four pulp-capping materials that were applied to the occlusal dentin surface. Two different distances were used between the tip of the unit and the material surface during polymerization; 0 and 2 mm. The data were statistically analyzed using factorial-ANOVA, one-way-ANOVA, and Tukey's HSD test. There were statistically differences between contact and noncontact groups (p<0.05). Contact groups produced significantly lower temperature rise compared with noncontact groups. The highest and lowest mean temperature increases were calculated for the Biner LC and the TheraCal LC, respectively. Considering the effects of temperature rising, the distance of the light curing units from restorations should not be overlooked as well as the types of the materials.

The bond strength of GICs is affected by tooth substrate. High-viscosity GICs show higher initial fluoride release as well as greater fluoride recharge capacity.

The aim of this study was to evaluate the preparation time and the amounts of apically extruded debris and irrigant using different nickeltitanium instrumentation systems. Forty-five extracted single-rooted mandibular premolar teeth were selected and divided into three groups. The root canals were instrumented according to the manufacturers' instructions, using a reciprocating single-file system, a single-file rotary system and a multiple-file rotary system. Bidistilled water was used as the irrigant solution. The apically extruded debris and irrigant were collected into preweighed Eppendorf tubes. The amounts of extruded debris and irrigant were assessed with a precision micro-balance. The Eppendorf tubes were incubated at 37°C for 15 days. After the incubation period, they were weighed again to assess the debris extrusion. The time required to prepare the canals was also recorded. The results were statistically analyzed using MANOVA and Bonferroni's adjustment. Considering the apically extruded debris and irrigant, there were no statistically significant differences among the groups (p > 0.05). The Reciproc group produced the highest debris (0.000632 ± 0.000162 gr) and irrigant (0.844587 ± 0.437814 ml) extrusion values. While the least extruded debris was observed with OneShape (0,000431 ± 0,000171 gr), the least extruded irrigant was observed with ProTaper system (0.564147 ± 0.370596 ml). Instrumentation was faster using the Reciproc than the other two instruments (70.27 ± 13.38 s) (p < 0.05). All of the instrumentation systems used in this study produced apical debris and irrigant extrusion. The reciprocating single-file system tended to produce more debris and irrigant extrusion, compared with the rotary systems. Considering the preparation time, the single-file systems appeared to be advantageous due to their working time.