Biocomposite materials based on Alfa cellulose fibers (esparto grass plant) as reinforcing element and starch‐based biopolymer matrix were prepared and characterized in terms of mechanical performance, thermal properties, and water absorbance behavior. The fibers and the matrix were first mixed in the melted state under mechanical shearing using a plastograph and the obtained composites were molded by injection process. The tensile mechanical analysis showed a linear increase of the composite flexural and tensile modulus upon increasing the fiber content, together with a sharp decrease of the elongation at break. The fibers′ incorporation into the biopolymer matrix brings about an enhancement in the mechanical strength and the impact strength of the composite. Dynamic mechanical thermal analysis (DMTA) investigation showed two relaxations occurring at about −30 and 35°C. The addition of Alfa fibers enhanced the storage modulus E′ before and after Tα, which is consistent with the reinforcing effect of Alfa cellulose fibers. Copyright © 2008 John Wiley & Sons, Ltd.

Films were fabricated using a mixture of polyvinyl alcohol (PVA)/cassava starch and incorporated citric acid in a concentration range between 5% and 40%. The films were annealed through thermal treatment in a temperature range between 30 °C and 90 °C with 0.3% glutaraldehyde incorporated as the crosslinking agent. This study presents the results of an experimental design analyzed using the response surface methodology. The multiple regression analysis allowed us to obtain the second-order models, which relate the annealing factors and citric acid concentration to Maximum Tensile Strength (MTS), Young’s Modulus (YM), and the Maximum Elongation at Break (MEB). The optimization and validation of the obtained model were carried out with error values below 10.08% for all the response variables, indicating that the response surface methodology and optimization were correct. Finally, as a complementary analysis, the differential scanning calorimetry (DSC) and Fourier-transform infrared spectroscopy (FTIR) tests were carried out, which revealed a higher packaging of the heat-treated films and verified their crosslinking.

Polymeric nanofibers are widely studied in the textile industry since with them, it is possible to get a great variety of functionalities. In this paper, polyamide 6/66 (PA 6/66) solutions at different concentrations (12, 17, and 22% wt.) were made, to get nanofibers through the basic electrospinning process which were characterized by scanning electron microscope (SEM) and productivity. Afterwards, nanofiber bundles were produced using the electrospinning sol–gel process, which were characterized by SEM and tensile test. From the results of statistical optimization based on one-way analysis of variance (ANOVA) with post hoc Tukey HSD, it was found that nanofiber bundles with higher productivity (1.39 ± 0.15 mg/min), draw ratio (9.0 ± 1.2), and tensile strength (29.64 ± 7.40 MPa) were obtained with a 17% concentration. Finally, a thermal characterization through differential scanning calorimetry (DSC) was done, finding evidence of a Tg and Tm reduction in the nanofibers in relation to PA 6/66 pellets and nanofiber bundles.