The objective of this study was to evaluate the influence of Er:YAG laser (λ = 2.94 μm) on microtensile bond strength (μTBS) and superficial morphology of bovine dentin bleached with 16% carbamide peroxide. Forty bovine teeth blocks (7 × 3 × 3 mm(3)) were randomly assigned to four groups: G1- bleaching and Er:YAG irradiation with energy density of 25.56 J/cm(2) (focused mode); G2 - bleaching; G3 - no-bleaching and Er:YAG irradiation (25.56 J/cm(2)); G4 - control, non-treated. G1 and G2 were bleached with 16% carbamide peroxide for 6 h during 21 days. Afterwards, all blocks were abraded with 320 to 600-grit abrasive papers to obtain flat standardized dentin surfaces. G1 and G3 were Er:YAG irradiated. Blocks were immediately restored with 4-mm-high composite resin (Adper Single Bond 2, Z-250-3 M/ESPE). After 24 h, the restored blocks (n = 9) were serially sectioned and trimmed to an hour-glass shape of approximately 1 mm(2) at the bonded interface area, and tested in tension in a universal testing machine (1 mm/ min). Failure mode was determined at a magnification of 100× using a stereomicroscope. One block of each group was selected for scanning electron microscope (SEM) analysis. μTBS data was analyzed by two-way ANOVA and Tukey test (α = 0.05). Mean bond strengths (SD) in MPa were: G1- 32.7 (5.9)(A); G2- 31.1 (6.3)(A); G3- 25.2 (8.3)(B); G4- 36.7 (9.9).(A) Groups with different uppercase letters were significantly different from each other (p < .05). Enamel bleaching procedure did not affect μTBS values for dentin adhesion. Er:YAG laser irradiation with 25.56 J/cm(2) prior to adhesive procedure of bleached teeth did not affect μTBS at dentin and promoted a dentin surface with no smear layer and opened dentin tubules observed under SEM. On the other hand, Er:YAG laser irradiation prior to adhesive procedure of non-bleached surface impaired μTBS compared to the control group.

Bleached enamel surfaces μTBS values were not significantly different from those of unbleached enamel. Even though Er:YAG laser irradiation with both parameters had no influence on μTBS for bleached and unbleached enamel, SEM analysis revealed that Er:YAG laser irradiation with 25.52  J/cm(2) should not be recommended, as enamel ablation was observed, whereas irradiation with 4.42 J/cm(2) did not promote any remarkable changes on enamel surface.

Background:The understanting of the dental fluorosis process, that begins with enamel maturation, is important to Dentistry students, since fluoride has drastically decreased the incidence of caries in several population groups, with a resultant increase in fluorosis prevalence and severity, as shown in literature.Aims:The objective of this paper is to report the changes in the level of knowledge about dental fluorosis of undergraduate Dentistry students at Guarulhos University.Subjects and Methods:One hundred and twenty-four undergraduate students enrolled in the first and second semester (2008) and seventh semester (2008) were evaluated. The data was obtained through questionnaires with dichotomic questions (true and false) and an alternative to evaluate whether the subject had been presented in the classroom. The data obtained was submitted to statistical analysis using the Chi-square test (α=0.05).Results:When evaluating the first semester students, differences were verified in numbers of the questions assigned with the alternatives true or false, when compared with seventh semester students (p<0.001). However, there were no differences when the same questionnaire was applied to the first semester students after six months (p=0.358).Conclusions:It is possible to conclude that the six months period was insufficient to increase the level of knowledge about dental fluorosis, and when the students beginning and concluding the dentistry course were compared, there was an increase in the number of correctly assigned true or false questions in the latter group.