During the ejection phase of the injection moulding cycle the parts are mechanically forced to separate from the moulding surfaces, this aspect being more relevant with deep cores. The design of the ejection system depends on factors such as the draft angles, the surface finish, and the properties of the moulding material at the ejection temperature and the dimensioning of actuation devices (e.g., hydraulic or pneumatic cylinders). Knowledge of the friction properties of the mating metal and plastics surfaces is important to optimize the ejection system. The coefficient of friction at the ejection stage depends on the surface texture of the core and the temperature at ejection. This paper reviews recent research on the static coefficient of friction in moulding conditions. It also reviews results obtained with a prototype apparatus that reproduces the conditions occurring during the ejection phase.

The in vitro effect of cadmium on apical segments of Hypnea musciformis was examined. Over a period of 7 days, the segments were cultivated with different concentrations of cadmium, ranging from 50 to 300 μM. The samples were processed for microscopic and histochemical analysis of growth rates, content of photosynthetic pigments, and photosynthetic performance. Cadmium treatments increased cell wall thickness and the accumulation of plastoglobuli. Destruction of chloroplast internal organization was observed. Compared to controls, algae exposed to cadmium showed growth rate reduction, depigmentation, and blending in the lateral branches. The content of photosynthetic pigments, including chlorophyll a and phycobiliproteins, decreased after exposure to different concentrations of cadmium. These results agree with the decreased photosynthetic performance and relative electron transport rate observed after exposure of algae to cadmium. Taken together, these findings strongly indicate that cadmium negatively affects the architecture and metabolism of the carragenophyte H. musciformis, thus posing a threat to the economic vitality of this red macroalgae.

The croton oil-induced mouse ear oedema test, acetic acid-induced abdominal writhing, and carrageenan-induced peritonitis were used to study the anti-inflammatory effects of the crude ethanol extract and its alkaloid fraction from Solanum lycocarpum fruits. The alkaloid fraction induced a dose-dependent reduction in ear oedema formation and leukocyte migration, suggesting that S. lycocarpum fruits may contain steroidal alkaloids accounting for the anti-inflammatory effect of the crude ethanol extract.

No abstract

Injection moulding is one of the most important technologies for the production of technical plastics parts. An increasing demand of moulds each time more complex and efficient needed exists. Simultaneously the time available for their design and manufacture is shorter, this enhancing the role of the design phase. For the design of the ejection systems, data related to the involved forces is necessary. In order to understand the particularities of the friction phenomena in the interface polymer/mould (steel), it is necessary to understand the replication process. Due to the very different nature of the materials involved (steel and polymers), different optical techniques were used to achieve a qualitative and a quantitative characterization of the surfaces involved.