We present a concept for a multistage Zeeman decelerator that is optimized particularly for applications in molecular beam scattering experiments. The decelerator consists of a series of alternating hexapoles and solenoids, that effectively decouple the transverse focusing and longitudinal deceleration properties of the decelerator. It can be operated in a deceleration and acceleration mode, as well as in a hybrid mode that makes it possible to guide a particle beam through the decelerator at constant speed. The deceleration features phase stability, with a relatively large six-dimensional phase-space acceptance. The separated focusing and deceleration elements result in an unequal partitioning of this acceptance between the longitudinal and transverse directions. This is ideal in scattering experiments, which typically benefit from a large longitudinal acceptance combined with narrow transverse distributions. We demonstrate the successful experimental implementation of this concept using a Zeeman decelerator consisting of an array of 25 hexapoles and 24 solenoids. The performance of the decelerator in acceleration, deceleration, and guiding modes is characterized using beams of metastable helium ( 3 S) atoms. Up to 60% of the kinetic energy was removed for He atoms that have an initial velocity of 520 m/s. The hexapoles consist of permanent magnets, whereas the solenoids are produced from a single hollow copper capillary through which cooling liquid is passed. The solenoid design allows for excellent thermal properties and enables the use of readily available and cheap electronics components to pulse high currents through the solenoids. The Zeeman decelerator demonstrated here is mechanically easy to build, can be operated with cost-effective electronics, and can run at repetition rates up to 10 Hz.

Zeeman deceleration is a relatively new technique used to obtain full control over the velocity of paramagnetic atoms or molecules in a molecular beam. We present a detailed description of a multistage Zeeman decelerator that has recently become operational in our laboratory [Cremers et al., Phys. Rev. A 98, 033406 (2018)], and that is specifically optimized for crossed molecular beams scattering experiments. The decelerator consists of an alternating array of 100 solenoids and 100 permanent hexapoles to guide or decelerate beams of paramagnetic atoms or molecules. The Zeeman decelerator features a modular design that is mechanically easy to extend to arbitrary length, and allows for solenoid and hexapole elements that are convenient to replace. The solenoids and associated electronics are efficiently water cooled and allow the Zeeman decelerator to operate at repetition rates exceeding 10 Hz. We characterize the performance of the decelerator using various beams of metastable rare gas atoms. Imaging of the atoms that exit the Zeeman decelerator reveals the transverse focusing properties of the hexapole array in the Zeeman decelerator.

Multistage Zeeman deceleration is a technique used to reduce the velocity of neutral molecules with a magnetic dipole moment. Here we present a Zeeman decelerator that consists of 100 solenoids and 100 magnetic hexapoles, that is based on a short prototype design presented recently [Phys. Rev. A 95, 043415 (2017)]. The decelerator features a modular design with excellent thermal and vacuum properties, and is robustly operated at a 10 Hz repetition rate. We use this decelerator to demonstrate for the first time the state-selective deceleration of atomic oxygen to final mean velocities in the 500 -125 m/s range. We characterize our decelerator further with molecular oxygen, which despite its heavier mass is velocity tuned in the 350 -150 m/s range. This corresponds to a maximum kinetic energy reduction of 95% and 80% for atomic and molecular oxygen, respectively. The long multistage Zeeman decelerator presented here demonstrates that the concept of using alternating hexapoles and solenoids is truly phase stable. This Zeeman decelerator is ideally suited for applications in crossed beam scattering experiments; the state-selected and velocity controlled samples of O atoms and O2 molecules are particularly relevant for studies of inelastic and reactive processes.