Future lunar, planetary, and asteroid exploration will strongly demandin situanalysis of rock samples to obtain data related to various aspects. For precise composition analysis, a sample surface should be smoothed. In this paper, a surface shaver with a piezoelectric actuator is proposed and its machining performance in air is investigated. Shaving teeth are mounted at the ends of a pair of lever mechanisms. The device is pressed through four springs onto the workpiece with a linear actuator. When a sinusoidal voltage of 50 Vp-pand an offset voltage of 25 V were applied, the resonance frequency was 556 Hz and the unloaded amplitude of the shaving teeth was 0.77 mmp-p. Basalt workpieces were machined for 10 min in air. Increasing the thrust force reduced the surface roughness, although the amount removed diminished with a further increase in the thrust force. The surface roughness varied widely not only due to the amount removed but also due to containing the pores.

No abstract