Macroporous ceramics with pore sizes from 400 nm to 4 mm and porosity within the range 20%-97% have been produced for a number of well-established and emerging applications, such as molten metal filtration, catalysis, refractory insulation, and hot gas filtration. These applications take advantage of the unique properties achieved through the incorporation of macropores into solid ceramics. In this article, we review the main processing routes that can be used for the fabrication of macroporous ceramics with tailored microstructure and chemical composition. Emphasis is given to versatile and simple approaches that allow one to control the microstructural features that ultimately determine the properties of the macroporous material. Replica, sacrificial template, and direct foaming techniques are described and compared in terms of microstructures and mechanical properties that can be achieved. Finally, directions to future investigations on the processing of macroporous ceramics are proposed.

Pump up the volume: Wet foams prepared with surfactants are thermodynamically unstable systems that undergo rapid disproportionation, drainage, and coalescence. Ultrastable foams have now been prepared using colloidal particles as stabilizers (left picture). The stabilization results from the irreversible adsorption at the air–water interface of particles surface‐modified with short‐chain amphiphiles (right picture).

Aqueous zinc batteries are highly attractive for large-scale storage applications owing to their inherent safety, low-cost, and durability. Yet, their advancement is hindered by a dearth of positive host materials (cathode) due to sluggish diffusion of Zn 2+ inside solid inorganic frameworks. Here, we report a novel organic host, tetrachloro-1,4-benzoquinone (also called: p-Chloranil), which due to its inherently soft crystal structure can provide reversible and efficient Zn 2+ storage. It delivers a high capacity of ≥200 mAh g-1 with a very small voltage polarization of 50 mV in a flat plateau around 1.1 V, which equate to an attractive specific energy of > 200 Wh kg-1 at an unparalleled energy efficiency (~95%). As unraveled by density functional theory (DFT) calculations, the molecular columns in p-Chloranil undergo a twisted rotation to accommodate Zn 2+ , thus restricting the volume change (-2.7%) during cycling. In-depth characterizations using operando X-ray

Bulk hierarchical porous ceramics with unprecedented strength-to-weight ratio and tunable pore sizes across three different length scales are printed by direct ink writing. Such an extrusion-based process relies on the formulation of inks in the form of particle-stabilized emulsions and foams that are sufficiently stable to resist coalescence during printing.

Wet foams are used in many important technologies either as end or intermediate products. However, the thermodynamic instability of wet foams leads to undesired bubble coarsening over time. Foam stability can be drastically improved by using particles instead of surfactants as foam stabilizers, since particles tend to adsorb irreversibly at the air-water interface. Recently, we presented a novel method for the preparation of high-volume particle-stabilized foams which show neither bubble growth nor drainage over more than 4 days. The method is based on the in-situ hydrophobization of initially hydrophilic particles to enable their adsorption on the surface of air bubbles. In-situ hydrophobization is accomplished through the adsorption of short-chain amphiphiles on the particle surface. In this work, we illustrate how this novel method can be applied to particles with various surface chemistries. For that purpose, the functional group of the amphiphilic molecule was tailored according to the surface chemistry of the particles to be used as foam stabilizers. Short-chain carboxylic acids, alkyl gallates, and alkylamines were shown to be appropriate amphiphiles to in-situ hydrophobize the surface of different inorganic particles. Ultrastable wet foams of various chemical compositions were prepared using these amphiphiles. The simplicity and versatility of this approach is expected to aid the formulation of stable wet foams for a variety of applications in materials manufacturing, food, cosmetics, and oil recovery, among others.