No abstract

In cutting operations of titanium alloys, most of the problems are related to the high consumption of cutting tools due to excessive wear. An improvement of metalworking fluid (MWF) technology would increase the productivity, sustainability, and quality of machining processes by lubricating and cooling. In this research article, the authors varied the surfactant’s charge, the hydrocarbon chain length, and the ethoxylation degree. Surfactants were dispersed at 1.2 mM in water and trimethylolpropane oleate to produce water-based MWF. Infrared reflection absorption spectroscopy and total organic carbon analysis were used to study the influence of surfactant structure on the film forming ability of the emulsion and performance was studied on Ti6Al4V using tapping torque test. The results showed that by changing the molecular structure of the surfactant, it is possible to vary the affinity between the ester and the substrate and reach an optimal combination, which improves the formation of a tribofilm. The mixture with anionic surfactants has good tribology performance, while non-ionic surfactants shorten the tool’s life. Moreover, the increase in the hydrocarbon chain length and the number of ethoxylations of surfactants promotes the adhesion of ester onto the metal surface, improving the lubricity properties of environmentally friendly MWF.

The machinability of titanium alloys still represents a demanding challenge and the development of new clean technologies to lubricate and cool is greatly needed. As a sustainable alternative to mineral oil, esters have shown excellent performance during machining. Herein, the aim of this work is to investigate the influence of esters’ molecular structure in oil-in-water emulsions and their interaction with the surface to form a lubricating film, thus improving the efficiency of the cutting fluid. The lubricity performance and tool wear protection are studied through film formation analysis and the tapping process on Ti6Al4V. The results show that the lubricity performance is improved by increasing the formation of the organic film on the metal surface, which depends on the ester’s molecular structure and its ability to adsorb on the surface against other surface-active compounds. Among the cutting fluids, noteworthy results are obtained using trimethylolpropane trioleate, which increases the lubricating film formation (containing 62% ester), thus improving the lubricity by up to 12% and reducing the torque increase due to tool wear by 26.8%. This work could be very useful for fields where often use difficult-to-machine materials—such as Ti6Al4V or γ-TiAl – which require large amounts of cutting fluids, since the formulation developed will allow the processes to be more efficient and sustainable.