Many tumor-targeted strategies have been used worldwide to limit the side effects and improve the effectiveness of therapies, such as chemotherapy, radiotherapy (RT), etc. Biophotonic therapy modalities comprise very promising alternative techniques for cancer treatment with minimal invasiveness and side-effects. These modalities use light e.g., laser irradiation in an extracorporeal or intravenous mode to activate photosensitizer agents with selectivity in the target tissue. Photothermal therapy (PTT) is a minimally invasive technique for cancer treatment which uses laser-activated photoabsorbers to convert photon energy into heat sufficient to induce cells destruction via apoptosis, necroptosis and/or necrosis. During the last decade, PTT has attracted an increased interest since the therapy can be combined with customized functionalized nanoparticles (NPs). Recent advances in nanotechnology have given rise to generation of various types of NPs, like gold NPs (AuNPs), designed to act both as radiosensitizers and photothermal sensitizing agents due to their unique optical and electrical properties i.e., functioning in dual mode. Functionalized AuNPS can be employed in combination with non-ionizing and ionizing radiation to significantly improve the efficacy of cancer treatment while at the same time sparing normal tissues. Here, we first provide an overview of the use of NPs for cancer therapy. Then we review many recent advances on the use of gold NPs in PTT, RT and PTT/RT based on different types of AuNPs, irradiation conditions and protocols. We refer to the interaction mechanisms of AuNPs with cancer cells via the effects of non-ionizing and ionizing radiations and we provide recent existing experimental data as a baseline for the design of optimized protocols in PTT, RT and PTT/RT combined treatment.

No abstract

Many different tumor-targeted strategies are under development worldwide to limit the side effects and improve the effectiveness of cancer therapies. One promising method is to enhance the radiosensitization of the cancer cells while reducing or maintaining the normal tissue complication probability during radiation therapy using metallic nanoparticles (NPs). Radiotherapy with MV photons is more commonly available and applied in cancer clinics than high LET particle radiotherapy, so the addition of high-Z NPs has the potential to further increase the efficacy of photon radiotherapy in terms of NP radiosensitization. Generally, when using X-rays, mainly the inner electron shells are ionized, which creates cascades of both low and high energy Auger electrons. When using high LET particles, mainly the outer shells are ionized, which give electrons with lower energies than when using X-rays. The amount of the produced low energy electrons is higher when exposing NPs to heavy charged particles than when exposing them to X-rays. Since ions traverse the material along tracks, and therefore give rise to a much more inhomogeneous dose distributions than X-rays, there might be a need to introduce a higher number of NPs when using ions compared to when using X-rays to create enough primary and secondary electrons to get the desired dose escalations. This raises the questions of toxicity. This paper provides a review of the fundamental processes controlling the outcome of metallic NP-boosted photon beam and ion beam radiation therapy and presents some experimental procedures to study the biological effects of NPs’ radiosensitization. The overview shows the need for more systematic studies of the behavior of NPs when exposed to different kinds of ionizing radiation before applying metallic-based NPs in clinical practice to improve the effect of IR therapy.

Membranes attract attention in medicine, concerning lipidome composition and fatty acid correlation with neurological diseases. Hyperspectral dark field microscopy (HDFM), a biophotonic imaging using reflectance spectra, provides accurate characterization of healthy adult RBC identifying a library of 8 spectral end-members. Here we report hyperspectral RBC imaging in children affected by Autism Spectrum Disorder (ASD) (n = 21) compared to healthy age-matched subjects (n = 20), investigating if statistically significant differences in their HDFM spectra exist, that can comprehensively map a membrane impairment involved in disease. A significant difference concerning one end-member (spectrum 4) was found (P value = 0.0021). A thorough statistical treatment evidenced: i) diagnostic performance by the receiving operators curve (ROC) analysis, with cut-offs and very high predictive values (P value = 0.0008) of spectrum 4 for identifying disease; ii) significant correlations of spectrum 4 with clinical parameters and with the RBC membrane deficit of the omega-3 docosahexaenoic acid (DHA) in ASD patients; iii) by principal component analysis, very high affinity values of spectrum 4 to the factor that combines behavioural parameters and the variable “cc” discriminating cases and controls. These results foresee the use of biophotonic methodologies in ASD diagnostic panels combining with molecular elements for a correct neuronal growth.

Much work has been done during the past few decades to develop effective drug delivery systems (DDS), many of which are based on nanotechnology science. Liposomes are the most attractive lipid vesicles for drug delivery. The multifunctional properties of liposomes have a key role in modifying the bioavailability profile of a therapeutic agent. Different analytical techniques can be used to describe liposomes, not least applied scanning probe microscopy (SPM) techniques. Atomic force microscopy (AFM) seems to be one of the most effectively applied SPM techniques. This review article outlines the applications of AFM in evaluating the physical characteristics and stability of liposomal DDSs. Other well-known microscopy techniques used in evaluating liposome physical characteristics are also mentioned, and the contribution of AFM to evaluating liposomal stability is discussed. Among the advantages of AFM in examining the physicochemical properties of liposomal DDSs is its ability to provide morphological and metrology information on liposome properties. AFM thus appears to be a promising tool in technological characterization of liposomal DDSs.