Background Ankle exoskeletons offer a promising opportunity to offset mechanical deficits after stroke by applying the needed torque at the paretic ankle. Because joint torque is related to gait speed, it is important to consider the user’s gait speed when determining the magnitude of assistive joint torque. We developed and tested a novel exoskeleton controller for delivering propulsive assistance which modulates exoskeleton torque magnitude based on both soleus muscle activity and walking speed. The purpose of this research is to assess the impact of the resulting exoskeleton assistance on post-stroke walking performance across a range of walking speeds. Methods Six participants with stroke walked with and without assistance applied to a powered ankle exoskeleton on the paretic limb. Walking speed started at 60% of their comfortable overground speed and was increased each minute (n00, n01, n02, etc.). We measured lower limb joint and limb powers, metabolic cost of transport, paretic and non-paretic limb propulsion, and trailing limb angle. Results Exoskeleton assistance increased with walking speed, verifying the speed-adaptive nature of the controller. Both paretic ankle joint power and total limb power increased significantly with exoskeleton assistance at six walking speeds (n00, n01, n02, n03, n04, n05). Despite these joint- and limb-level benefits associated with exoskeleton assistance, no subject averaged metabolic benefits were evident when compared to the unassisted condition. Both paretic trailing limb angle and integrated anterior paretic ground reaction forces were reduced with assistance applied as compared to no assistance at four speeds (n00, n01, n02, n03). Conclusions Our results suggest that despite appropriate scaling of ankle assistance by the exoskeleton controller, suboptimal limb posture limited the conversion of exoskeleton assistance into forward propulsion. Future studies could include biofeedback or verbal cues to guide users into limb configurations that encourage the conversion of mechanical power at the ankle to forward propulsion. Trial registration N/A. Electronic supplementary material The online version of this article (10.1186/s12984-019-0523-y) contains supplementary material, which is available to authorized users.

Degenerative wear to the glenoid from repetitive loading can reduce effective concavity depth and lead to future instability. Workspace design should consider glenohumeral stability to prevent initial wear. While glenohumeral stability has been previously explored for activities of daily living including push–pull tasks, whether stability is spatially dependent is unexplored. We simulated bimanual and unimanual push–pull tasks to four horizontal targets (planes of elevation: 0 deg, 45 deg, 90 deg, and 135 deg) at 90 deg thoracohumeral elevation and three elevation targets (thoracohumeral elevations: 20 deg, 90 deg, 170 deg) at 90 deg plane of elevation. The 45 deg horizontal target was most stable regardless of exertion type and would be the ideal target placement when considering stability. This target is likely more stable because the applied load acts perpendicular to the glenoid, limiting shear force production. The 135 deg horizontal target was particularly unstable for unimanual pushing (143% less stable than the 45 deg target), and the applied force for this task acts parallel to the glenoid, likely creating shear forces or limiting compressive forces. Pushing was less stable than pulling (all targets except sagittal 170 deg for both task types and horizontal 45 deg for bimanual) (p < 0.01), which is consistent with prior reports. For example, unimanual pushing at the 90 deg horizontal target was 197% less stable than unimanual pulling. There were limited stability benefits to task placement for pushing, and larger stability benefits may be seen from converting tasks from push to pull rather than optimizing task layout. There was no difference in stability between bimanual and unimanual tasks, suggesting no stability benefit to bimanual operation.

No abstract

Background Weakness of ankle and knee musculature following injury or disorder results in reduced joint motion associated with metabolically expensive gait compensations to enable limb support and advancement. However, neuromechanical coupling between the ankle and knee make it difficult to discern independent roles of these restrictions in joint motion on compensatory mechanics and metabolic penalties. Methods We sought to determine relative impacts of ankle and knee impairment on compensatory gait strategies and energetic outcomes using an unimpaired cohort (N = 15) with imposed unilateral joint range of motion restrictions as a surrogate for reduced motion resulting from gait pathology. Participants walked on a dual-belt instrumented treadmill at 0.8 m s−1 using a 3D printed ankle stay and a knee brace to systematically limit ankle motion (restricted-ank), knee motion (restricted-knee), and ankle and knee motion (restricted-a + k) simultaneously. In addition, participants walked without any ankle or knee bracing (control) and with knee bracing worn but unrestricted (braced). Results When ankle motion was restricted (restricted-ank, restricted-a + k) we observed decreased peak propulsion relative to the braced condition on the restricted limb. Reduced knee motion (restricted-knee, restricted-a + k) increased restricted limb circumduction relative to the restricted-ank condition through ipsilateral hip hiking. Interestingly, restricted limb average positive hip power increased in the restricted-ank condition but decreased in the restricted-a + k and restricted-knee conditions, suggesting that locking the knee impeded hip compensation. As expected, reduced ankle motion, either without (restricted-ank) or in addition to knee restriction (restricted-a + k) yielded significant increase in net metabolic rate when compared with the braced condition. Furthermore, the relative increase in metabolic cost was significantly larger with restricted-a + k when compared to restricted-knee condition. Conclusions Our methods allowed for the reproduction of asymmetric gait characteristics including reduced propulsive symmetry and increased circumduction. The metabolic consequences bolster the potential energetic benefit of targeting ankle function during rehabilitation. Trial registration N/A.

No abstract