Fenton's reagent was used to isolate microplastics from organic-rich wastewater. The catalytic reaction did not affect microplastic chemistry or size, enabling its use as a pre-treatment method for focal plane array-based micro-FT-IR imaging. Compared with previously described microplastic treatment methods, Fenton's reagent offers a considerable reduction in sample preparation times.

The volatile compounds released by orthodox (desiccation-tolerant) seeds during ageing can be analysed using gas chromatography–mass spectrometry (GC-MS). Comparison of three legume species (Pisum sativum, Lathyrus pratensis, and Cytisus scoparius) during artificial ageing at 60% relative humidity and 50 °C revealed variation in the seed volatile fingerprint between species, although in all species the overall volatile concentration increased with storage period, and changes could be detected prior to the onset of viability loss. The volatile compounds are proposed to derive from three main sources: alcoholic fermentation, lipid peroxidation, and Maillard reactions. Lipid peroxidation was confirmed in P. sativum seeds through analysis of malondialdehyde and 4-hydroxynonenal. Volatile production by ageing orthodox seeds was compared with that of recalcitrant (desiccation-sensitive) seeds of Quercus robur during desiccation. Many of the volatiles were common to both ageing orthodox seeds and desiccating recalcitrant seeds, with alcoholic fermentation forming the major source of volatiles. Finally, comparison was made between two methods of analysis; the first used a Tenax adsorbent to trap volatiles, whilst the second used solid phase microextraction to extract volatiles from the headspace of vials containing powdered seeds. Solid phase microextraction was found to be more sensitive, detecting a far greater number of compounds. Seed volatile analysis provides a non-invasive means of characterizing the processes involved in seed deterioration, and potentially identifying volatile marker compounds for the diagnosis of seed viability loss.

No abstract

No abstract

The migration of melamine and formaldehyde, monomers used in the production of melamine-ware food contact articles, has been determined from 50 retail articles purchased in the UK. The food simulant 3% aqueous acetic acid was used as this is the most aggressive simulant towards melamine plastics. The test conditions used were repeated exposure to the simulant for 2 hours at 70 degrees C, since the articles were all intended for general use including contact with hot foods and beverages. Melamine migrated from 43 of the 50 samples tested and formaldehyde migrated from all 50 samples. Directive 2002/72/EC specifies migration limits for both of these monomers in foods and food simulants. Melamine is restricted by a specific migration limit (SML) of 30 mg/kg (equivalent to 5 mg/dm(2)) and formaldehyde, along with hexamethylenetetramine expressed as formaldehyde, is restricted by a total (T) SML(T) of 15 mg/kg (equivalent to 2.5 mg/dm(2)). In all cases the migration of melamine was much lower than the SML for this monomer. The migration of formaldehyde exceeded the SML(T) for 5 of the 50 samples tested. The failure to comply with the SML(T) was accompanied by a number of visible surface effects including discolouration and/or pitting of the simulant contact surface and cracking of the articles. Similar surface effects were observed when one of the samples was exposed to fruit juice which confirmed the suitability of the exposure conditions and 3% acetic acid as a simulant for the articles tested. The ratio of specific migration to overall migration was consistent with, but did not prove, the hypothesis that high formaldehyde migration could be due to the use of excessive hexamethylenetetramine in the polymer formulation. All illegal products were voluntarily removed from the market by the product suppliers.