The paper investigates the hypothesis that biotoxicities of trace metals depend not only on the concentration as expressed by the total amount, but also on their geochemical fractions and bioavailability. Airborne particles were collected using SKC Air Check XR 5000 high volume Sampler at a human breathing height of 1.5–2.0 meters, during the dry season months from November 2014 to March 2015 at different locations in Akure (7°10′N and 5°15′E). The geochemical-based sequential extractions were performed on the particles using a series of increasingly stringent solutions selected to extract metals (Cd, Cu, Cr, Ni, Pb, Zn, and Mn) into four operational geochemical phases—exchangeable, reducible, organic, and residual—and then quantified using an Atomic Absorption Spectrophotometer. The results showed metals concentration of order Pb > Cr > Cd > Zn > Ni > Cu > Mn. However, most metals in the samples exist in nonmobile fractions: exchangeable (6.43–16.2%), reducible (32.58–47.39%), organic (4.73–9.88%), and residual (18.28–27.53%). The pollution indices show ingestion as the leading route of metal exposure, with noncarcinogenic (HQ) and cancer risk (HI) for humans in the area being higher than 1.0 × 10−4, indicating a health threat.

The relative contribution of individual volatile organic compounds (VOC) species to photochemical ozone formation depends on their atmospheric concentrations and their oxidation mechanism. In an attempt to evaluate the ozone creation potential of ambient VOCs captured in an urban settlement of Benin City, Nigeria, the VOCs concentrations data collected in field studies at nine measurement sites of different air quality in the city and a background site were analysed. Air samples were collected at human breathing height of 1.5 meters from ground level at each site. Active sampling method using the low volume sampling pump (Acuro, Drager, Lubeck, Germany) was used to drawn the air into the tube; the absorbent was Chromosorb 106. The sampling periods were between May 2010 and June 2011; the period covered both dry and wet seasons. The adsorbed gases were desorbed using solvent extraction method with carbon disulphide as solvent. The extracted solutions were analyzed with gas chromatography and mass spectrometer. The observed concentrations of individual VOCs were determined and maximum incremental reactivity (MIR) coefficient along with rate constants of VOC-OH reactions were applied to assess the ozone formation potential of individual VOC in the ambient atmosphere. Sixteen VOC species were observed at various sites with mixing height in decreasing order: toluene (5.82), mp-xylene (3.58), ethylbenzene (3.46), benzene (2.29), and n-butane (0.84). The ozone formation potential study revealed that, ranking by propyl-equivalent, the alkanes included in this study account for 58% of the total propyl-equivalent concentration. The total ozone creation potential in the atmosphere of the Benin City was calculated to be 281.1 µg/m3. A comparison of total ozone formation potential (OFP) in our study with results obtained from other cities of the world revealed that the total concentration of ozone production in our study is threefold lower than the values reported in China city of Foshan. It is suggested that the sources of this pollutant need to be monitored in the area as a way of curtailing the impact of ozone in this city.

Organic pollutants in water and wastewater have been causing serious environmental problems. The arbitrary discharge of wastewater by industries, and handling, use, and disposal constitute a means by which phenols, flame retardants (FRs), phthalates (PAEs) and other toxic organic pollutants enter the ecosystem. Moreover, these organic pollutants are not completely removed during treatment processes and might be degraded into highly toxic derivatives, which has led to their occurrence in the environment. Phenols, FRs and PAEs are thus highly toxic, carcinogenic and mutagenic, and are capable of disrupting the endocrine system. Therefore, investigation to understand the sources, pathways, behavior, toxicity and exposure to phenols, FRs and PAEs in the environment is necessary. Formation of different by-products makes it difficult to compare the efficacy of the treatment processes, most especially when other organic matters are present. Hence, high levels of phenols, FRs and PAEs removal could be attained with in-line combined treatment processes.

Abstract:In this study, we attempted to verify the hypothesis that total metals bound to dust of different particle sizes may reflect pollution levels, but cannot predict its bioavailability and risks in human health assessments. Dust samples were collected using active sampling method; during the dry season months of November, 2014 to March, 2015 at different locations in Akure (7˚10ʹN and 5˚15ʹE). The samples were sorted into different particle sizes (< 10µm, 10 -50 µm, >50µm), analyzed for some physicochemical properties and assessed for metals bioavailability using two-step physiological extraction method. The amount of metals (Cd, Cu, Cr, Ni, Pb, Zn and Mn) released in each particle sizes were determined using Perkin-Elmer 6000 Inductively Coupled Plasma -Atomic Emission Spectrometry (ICP-AES) analysis. The results showed that bioavailability of some metals (Cd, Ni, Pb, and Zn) decreases with increasing particle sizes, however, the reverse trend was observed for Mn, Cu and Fe concentrations. This may be attributed to some combination of physicochemical characteristics of the dust and metal speciation. Hence, it was concluded that metal bioaccessibility in dust can best be described by the knowledge of physicochemical characteristics. The exposure dose of the metals showed that cancer risks due to inhalation were very high when compared to other exposure routes (ingestion and dermal contact). The calculated non-cancer (HQ) and cancer risk (HI) for humans in the area showed values higher than unity, indicating possibility of the metals' body burden. Key Words: dust; bioavailability; particle sizes; heavy metals; health risk; exposure IntroductionDusts are finely divided particulate matters that are generated during human activities; sweeping, quarrying, metal fabrication, etc and are readily lifted by wind. Once generated and released to the atmosphere, they travel long distances from emission point source by turbulent atmospheric currents and finally settles either by gravity under condition of calm or brought to the surface by precipitation [1]. In the course of transportation, the suspended metals are loaded to particulates; hence the dust creates a reserve pool of metals in urban atmosphere [2]. In recent time, nonoccupational exposures to dusts in urban atmosphere worldwide have aroused much attention due to its associated health effects. For example, on breathing air containing metal laden particles, the smaller particles can reach the wind-pipe (trachea) and eventually dissolve in the blood stream. According to TUC [3], the two most serious health problems associated with dust are; cancers of the lungs, throat and nose, and other lung conditions called chronic obstructive pulmonary diseases (COPD) which include chronic bronchitis and emphysema. A report in 2007 gave a likely figure of between 7,000 and 8,000 for cancers of the lung and the nose due to exposure dust at work [2].

No abstract