The stone artifacts in Bronze age from the Sinsongri sites in Seosan, Korea were studied on material characteristics and provenance presumptions. The use and rock names of the artifacts are a stone before processing, two semifinished stone arrowheads and a grinding stone plate by slates. In addition, there is semifinished stone arrowhead by andesitic rocks. The slate could be observed easily around the site, and the andesitic rock could be confirmed typical occurrences of the all kinds of rocks around the Kanwoldo and Hwangdori, Anmyun area above 10km from the site. As a result of analysis which is comparing between stone artifacts and same kinds of raw material rocks, the stone artifacts made by slates have similar lithology and geochemical characteristics however, the stone artifacts made by andesitic rocks are found a some different part of characteristics to the same kind of raw material rocks. Comparing of major, rare earth, compatible and incompatible elements about stones artifacts made by slates and by the same kinds of raw material rocks have same geochemical patterns. However stone artifacts made by andesites and the raw material rocks are confirmed some differences of geochemistry. Therefore the slate stone artifacts in Sinsongri site suggest that these

The excavated potteries and raw clays of the Bronze Age from the archaeological sites in the Cheonan-Asan area were studied on material scientific characteristics and homogeneity. Under the microscope, grainsize of the tempers in the potteries were distributed from less than 1mm to 10mm. Microtexture of the potteries showed various shapes and sizes of pores. In addition to the main minerals such as quartz, feldspar, mica, hornblende, chlorite and talc were found from the X-ray diffraction analysis of potteries, while talc was not found in the raw clay. Therefore, it was considered as an artificially added mineral. Firing temperature of the potteries, which did not contain chlorite, are assumed that they were baked below 850℃. On the other hand, the potteries which had mica and talc, are assumed that they were fired below 900℃. The geochemical characteristics of the potteries and raw clays showed very similar patterns, that means the potteries were produced by using the raw clay sources from each site.