BackgroundThe study aims to determine the nutritional value of hemp seed expressed by the oil content and by the concentration of metals (Ca, Mg, K, Fe, Mn, Zn and Cd), for five varieties of monoecious and dioecious hemp seeds approved in Romania, comparative with the concentration of these metals in the soil.ResultsThe content of oil in hempseed registers a slight decrease in the production records of 2011, losses due to drought and low levels of precipitation during the growth period. The greatest loss is found in Diana monoecious variety (26.54-20.82%) followed by Zenit varieties (27.37-22.97%), Armanca (29.27-25.32%), Silvana (28.89-25.04%) and Denise (26.96-25.30%). Siccative hemp oil has a yellowish green color and an iodine index of 140–156 g I2/100 g oil. Hemp seed are rich in mineral based Ca (144–955 mg/100 g seed), Mg (237–694 mg/100 g seed), K (463–2821 mg/100 g seed), Fe (1133-2400 mg.kg-1), Mn (63–110 mg.kg-1) and Zn (42-94 mg.kg-1). For the soil the following macroelements concentrations were determined: Ca (2100–2520 mg.kg-1), Mg (320–376 mg.kg-1) and K (232–257 mg.kg-1). Mn (156–197 mg.kg-1) and Zn (54–67 mg.kg-1) remain within normal limits for Romania. The soils in the experience area contain large amounts of Fe (19000–20430 mg.kg-1). The presence of K in large quantities determines the accumulation of large quantities of Fe in the soil.ConclusionHempseed belonging to the five Romanian varieties are rich source of nutrients (Ca, Mg, K) and unsaturated oil easily digestible by the body, but the presence of Cd concentrations above the upper limit puts a question mark over the use of seeds in various food products. Hemp extracts easily certain metals from the soil. Significant amounts of Fe (1133–2400 mg.kg-1), Mn (63–110 mg.kg-1), Zn (42–94 mg.kg-1) and Cd (1.3-4.0 mg.kg-1) are found in hemp seeds. Hemp (Cannabis sativa L.) is included among plants suitable for phytoremediation of soil contaminated with cadmium, zinc and iron.

Abstract:The structural changes induced in extra virgin olive oil (EVOO) by adulteration with soybean oil (SBO) and heat treatment at 185°C for 4 and 8 h were investigated using Attenuated Total Reflectance -Fourier Transform Infrared (ATR-FTIR) spectroscopy. Our results revealed that the band around 3006 cm -1 recorded shifts versus the percentage of adulterant. The changes in the absorbance at 3006 cm -1 (A3006) and in the ratio of the maximum heights of the bands at 3006 and 2925 cm −1 (A3006/A2925) were used to evaluate the EVOO adulteration. The regression analysis of A3006 and A3006/A2925 versus the percentage of adulterant was used to calculate the detection limits of adulteration. The time course of spectral changes showed that the oil heating caused notable modifications in the intensity of the absorption bands and induced no shifts in their exact position. The most relevant changes were reflected by conjugation and cis-trans isomerisation of double bonds, the formation of epoxides and widening of the band in the C=O region due to formation of secondary oxidation products. This study highlights that ATR-FTIR spectroscopy may be a promising means to differentiate among pure and adulterated oils and to study the thermooxidative processes in oils undergoing thermal stress.

The purpose of this paper is to evaluate the nutritional, phytochemical, rheological, technological, and sensory properties of wheat flour dough and bread under a replacement of lupin flour at level 10, 20, and 30%. In this sense, the proximate composition, fatty acids profile, the content in total polyphenols content (TPC), antioxidant activity (AA), and flavonoids content (TFC) of lupin; wheat and flour composites; and the bread obtained from them were determined. The rheological properties of the dough using the Mixolab system were also evaluated. The results showed an improvement in the nutritional properties of bread with addition of lupin in the composite flour, especially in terms of proteins, lipids, and mineral substances and a significant increases of functional attributes, such as TPC, TFC, and AA, which recorded the highest values in the bread with 30% lupin flour (76.50 mg GAE/100 g, 8.54 mg QE/100 g, 54.98%). The decrease of lupin bread volume compared to wheat bread ranged between 0.69–7.37%, porosity between 6.92–35.26%, elasticity between 63–70%, and H/D between 3.17–19.05%. The rheological profile of the dough obtained with lupin flours indicates a moderate stability and proper kneading behavior. The sensory analysis was also performed in order to identify the consumer’s acceptability regarding this type of bread. According to a 5-point hedonic scale, the most highly appreciated was the bread with 10% lupin flour, which obtained mean scores of 4.73 for general acceptability as compared with control bread (4.43).

BackgroundIn the last years essential oils from different plants were used in the prevention of fungi and mycotoxins accumulation in cereals. The most attractive aspect derived from using of essential oils as seed grains protectants is due to their non-toxicity. This study was focused on assessment the inhibitory effect of some essential oils: Melissa officinalis (O1), Salvia officinalis (O2), Coriandrum sativum (O3), Thymus vulgaris (O4) Mentha piperita (O5) and Cinnamomum zeylanicum (O6) against natural mycoflora and Fusarium mycotoxins production correlated with their antioxidants properties.ResultsAll essential oils showed inhibitory effect on fungal contamination of wheat seeds. This ability was dose-dependent. The highest inhibitory effect on Fusarium and Aspergillus fungi was recorded after 5 days of treatment. Fungi such as yeast (Pichia, Saccharomyces and Hyphopichia) were predominantly on seeds mycoflora after 22 days. Each treatment had a selective inhibitory effect on frequency of fungus genera. After 5 days of treatment the most fungicidal effect was recorder for O4, followed by O1. In terms of essential oils effect on mycotoxins development, the best control on fumonisins (FUMO) production was recorded for O6. The antioxidant properties of essential oils decreased in order: O4 > O1 > O6 > O5 > O2 > O3. Also, our data suggested that there is a significant negative correlation between antioxidant properties and seed contamination index (SCI), but there was not recorded a good correlation between antioxidant properties and FUMO content.ConclusionsBased on proven antifungal and antimycotoxin effects as well as their antioxidant properties, the essential oils could be recommended as natural preservatives for stored cereals. The highest inhibition of fungal growth was noted after 5 days of treatment and decreased after 22 days.

Betulin and betulinic acid are pentacyclic triterpenes present in the bark of the birch tree and other vegetal sources. Quantitatively, in birch bark betulin is more significant than betulinic acid; therefore, birch can be a large and feasible source of raw material for betulin extraction. Betulin can be used as extracted or, after chemical modification, as a starting compound for its acid, betulinic acid, with both substances possessing various interesting pharmacological properties. The purpose of this study is to analyse the betulin and betulinic acid content of a birch tree bark extract, as well as its cytotoxic activity. The extraction was done using a Soxhlet extractor and chloroform/dichlormethane/methanol (1 : 1 : 1) as solvent. The betulin and betulinic acid content of the extract was estimated using standards of pure betulin and betulinic acid, by thermal analysis as opposed to pure substance (thermogravimetric and differential thermal analysis). The extract and the main compounds were also analysed by NMR. The results indicated a high amount of betulin in the final extract (up to 50%), and an important quantity of betulinic acid: over 3%. The cytotoxic activity indicated a high proliferation inhibition for the birch tree extract but was still comparable with betulinic acid and betulin.