The influence of a surface-active substance (SAS) film on the Doppler spectrum width at small incidence angles is theoretically investigated for the first time for microwave radars with narrow-beam and knife-beam antenna patterns. It is shown that the requirements specified for the antenna system depend on the radar motion velocity. A narrow-beam antenna pattern should be used to detect slicks by an immobile radar, whereas radar with a knife-beam antenna pattern is needed for diagnostics from a moving platform. The study has revealed that the slick contrast in the Doppler spectrum width increases as the radar wavelength diminishes, thus it is preferable to utilize wavelengths not larger than 2 cm for solving diagnostic problems. The contrast in the Doppler spectrum width is generally weaker than that in the radar backscattering cross section; however, spatial and temporal fluctuations of the Doppler spectrum width are much weaker than those of the reflected signal power. This enables one to consider the Doppler spectrum as a promising indicator of slicks on water surface.

In the radar remote sensing of sea ice, the main informative parameter is the backscattering radar cross section (RCS), which does not always make it possible to unambiguously determine the kind of scattering surface (ice/sea waves) and therefore leads to errors in estimating the area of the ice cover. This paper provides a discussion of the possibility of using the Doppler spectrum of the reflected microwave signal to solve this problem. For the first time, a semi-empirical model of the Doppler spectrum of a radar microwave signal reflected by an ice cover was developed for a radar with a wide antenna beam mounted on a moving carrier at small incidence angles of electromagnetic waves (0°–19°). To describe the Doppler spectrum of the reflected microwave signal, the following parameters were used: shift and width of the Doppler spectrum, as well as skewness and kurtosis coefficients. Research was conducted on the influence of the main parameters of the measurement scheme (movement velocity, width of antenna beam, sounding direction, incidence angle) and the sea ice concentration (SIC) on the parameters of the Doppler spectrum. It was shown that, in order to determine the kind of scattering surface, it is necessary to use a wide or knife-like (by the incidence angle) antenna. Calculations confirmed the assumption that, when measured from a moving carrier, the Doppler spectrum is a reliable indicator of the transition from one kind of scattering surface to another. The advantage of using the coefficients of skewness and kurtosis in the analysis is that it is not necessary to keep the radar velocity unchanged during the measurement process.

Abstract:The use of a nadir altimeter radar with a rotating knife-beam antenna pattern is considered for improved measurements of the sea surface wind and wave parameters over a wide swath. Theoretical calculations suggest the antenna beam rotating about the vertical axis is able to provide wide swath of order 250-350 km. Processing of the signals using time or Doppler sampling techniques results in the division of the antenna footprint into elementary scattering cells of the order of 14x14 km. The theoretical algorithms developed here indicate that the system may be used to retrieve the variance of large-scale slopes, the direction of wave propagation and the wind speed in each cell. The possibility of measuring significant wave height is also analyzed. The combination of linear motion of the radar and the rotation of the knife-beam antenna can be exploited to build up a two-dimensional map of the surface, which enables better understanding of wave processes and to study their structure and temporal dynamics using repeated observations.

No abstract