Although free-cement-based alkali-activated paste, mortar, and concrete have been recognised as sustainable and environmental-friendly materials, a considerable amount of effort is still being channeled to ascertain the best binary or ternary binders that would satisfy the requirements of strength and durability as well as environmental aspects. In this study, the mechanical properties of alkali-activated mortar (AAM) made with binary binders, involving fly ash (FA) and granulated blast-furnace slag (GBFS) as well as bottle glass waste nano-silica powder (BGWNP), were opti-mised using both experimentally and optimisation modelling through three scenarios. In the first scenario, the addition of BGWNP varied from 5% to 20%, while FA and GBFS were kept constant (30:70). In the second and third scenarios, BGWNP (5–20%) was added as the partial replacement of FA and GBFS, separately. The results show that the combination of binary binders (FA and GBFS) and BGWNP increased AAM’s strength compared to that of the control mixture for all scenarios. In addition, the findings also demonstrated that the replacement of FA by BGWNP was the most significant, while the effect of GBFS replacement by BGWNP was less significant. In particular, the highest improvement in compressive strength was recorded when FA, GBFS, and BGWNP were 61.6%, 30%, and 8.4%, respectively. Furthermore, the results of ANOVA (p values < 0.0001 and high F-values) as well as several statistical validation methods (R > 0.9, RAE < 0.1, RSE < 0.013, and RRSE < 0.116) confirmed that all the models were robust, reliable, and significant. Similarly, the data variation was found to be less than 5%, and the difference between the predicted R2 and adj. R2 was very small (<0.2), thus confirming that the proposed non-linear quadratic equations had the capability to predict for further observation. In conclusion, the use of BGWNP in AAM could act as a beneficial and sustainable strategy, not only to address environmental issues (e.g., landfill) but to also enhance strength properties.

The feasibility of strengthening deteriorated or under-capacity concrete structures with external carbon-fiber-reinforced polymer (CFRP) laminates has been widely validated in the literature. However, there is a lack of knowledge on the in situ long-term performance and age-related environmental degradation of the mechanical properties of the laminates. The current study involved the immersion of coupons from a common new CFRP laminate in heated water at 23, 45, and 60 °C for 224 days. The coupons were then tested for residual tensile properties, such as tensile capacity and elastic modulus, using ASTM D3039 (2017) specifications. The CFRP tensile capacity and elastic modulus decreased by a maximum of 33% and 26%, respectively, for 224 days of exposure. Based on the test data, an age-based long-term prediction model with excellent reliability for CFRP laminate tensile capacity was developed. The model was then calibrated with test results from old CFRP coupons collected from an existing CFRP laminate retrofitted concrete bridge. The calibrated model output was then compared with the environmental reduction factor from ACI 440.2R-17 and a few other common sources. It was found that the ACI specified a reduction factor of 0.75, which does not consider the CFRP age and overestimates the design tensile strength of the CFRP laminate by approximately 13%, which may compromise the structural safety of retrofitted bridges. The reduction factors from the other guidelines varied between 0.51 and 0.85.